Do you have a question about the X7 and is the answer not in the manual?
Questions and answers
Summary of Contents for Hiberno X7
Page 1
Hiberno ELECTRIC SUCTION BLACKHEAD REMOVER X7 MODEL USER MANUAL Please read this manual carefully before using this product and keep safe for future reference. It is designed to help you get the most out of your purchase.
Page 2
The Hiberno Blackhead Remover is designed to help in the treatment of blackheads, removal of grease, dirt and dead skin. It has an added function whereby it rejuvenates your skin. There are 5 replaceable probes included in your purchase. Each has a different function and will be described within this manual.
Page 3
Charge your device for 2 hours. This will ensure that your battery lasts longer. Ensure the filter sponge has been placed in the filter. Your skin should be dry as otherwise moisture will be sucked into the machine making it ...
Page 4
Switch the device on by pressing the button on the front of your device. This automatically activates the ‘Low’ suction mode. Pressing the same button again will activate ‘medium’ suction mode and again for ‘high’ suction mode. Press again for Blue light technology and again for Red light technology. To stop your device at any time just press and hold the button for 2 SECONDS.
Page 5
OVERVIEW: Slowly move the device close to your skin It has powerful suction so there is no need to press it into your skin For best results move the device slowly across your skin. The correct way to use the device is to move it in one direction. Do not move it back ...
Wash your face with warm water to remove any excess dirt or oils Place hot water on a washcloth Wring out any excess water Place the washcloth over your face to steam out your pores When the washcloth cools, repeat the process 4 times over 10-15 minutes ...
Page 7
EXFOLIATION OF YOUR FACE Use the Microcrystalline probe. Clean your face and dry it Starting from the lower jaw, move the device from bottom to top On your cheek, move it from inside to outside On your forehead start in the middle and move it to each side On the T of your face move the device from bottom to top CARE LINES Use the Oval hole probe.
Page 8
We recommend that you use this function daily for best results. Cool Fact! This is a new technology and you may notice this when drying your hands using air dryers in bathrooms across the country. AFTERCARE FOR YOUR FACE We recommend using a moisturiser after using the Hiberno Blackhead Remover...
Page 9
Microcrystalline probe The surface of this probe is covered in microcrystals which have absorption properties. This helps to massage the skin and achieves an exfoliating effect. It should not be used around the eyes or where the skin is very thin. Medium round hole probe This probe is used for the treatment of blackheads, grease, dust and cosmetics residue etc.
Page 10
Oval hole probe This probe can be used on a daily basis. It is ideal for the corners of the mouth or around your eyes. Remember that 2 seconds is the maximum recommended time for all of these probes. With this probe we recommend going from bottom to top. It can be used to tighten skin on your face, cheeks, nose, mouth etc.
Page 11
Red/Blue light probe Silicone Round Hole Probe Oval Hole Probe Microlite probe Medium round hole probe Microlite probe Massages skin and removes dead skin and keratin Red/Blue light probe Shrinks Pores and rejuvenates skin after use of product. Medium round hole probe Treatment of blackheads, grease, dust and cosmetics residue etc.
Page 12
Do not use this product if your skin has any scars, cuts or open wounds. The device creates a powerful suction so there is no need to press the unit into the skin. You may notice a little redness after use. This is totally normal and will disappear after a short time. ...
Need help?
Do you have a question about the X7 and is the answer not in the manual?
Questions and answers