Ron Francis Wiring BX-10 Quick Start Manual

Advertisement

Part Number: BX-10
The BX-10 is a fully programmable, state of the art relay system that allows full control over each of the
10 individual 20 amp relayed circuits. Please read through the instructions completely to fully understand
how this unit operates.

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the BX-10 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Ron Francis Wiring BX-10

  • Page 1 Part Number: BX-10 The BX-10 is a fully programmable, state of the art relay system that allows full control over each of the 10 individual 20 amp relayed circuits. Please read through the instructions completely to fully understand how this unit operates.
  • Page 2 Programming: With the ignition on or off you can wake up the BX-10 by pressing any button for two seconds. Once the unit is active, press any relay circuit button for two seconds and the light for that relay circuit will light up and the selector buttons will reflect how that relay circuit is programmed.
  • Page 3 To program two relay circuits together: If you need more than 20 amps capacity for any relay circuit, two relays can be programmed together for 40 amps of capacity. Use the lowest number trigger to activate the two relays. Only one trigger is necessary.
  • Page 4 This is the m ain power for the unit. Using the pre-term inated ring term inal, connect the wire to the + term inal/screw on the BX-10 and run to a good battery power location. Preferably the starter solenoid or wherever the battery cable is attached to.
  • Page 5 The RELAY 9 wire connects to the device you are wanting to control. RELAY 10 Dark Blue The RELAY 10 wire connects to the device you are wanting to control. Need Help? Call our techline at 610-485-1981 Ron Francis Wiring 200 Keystone Rd. Chester, PA 19013 610-485-1981 www.ronfrancis.com Copyright 2015 Ron Francis' ©...

Table of Contents