Summary of Contents for SWIMN S1
- Page 1 SWIMN S1 User Manual Amazing Pool Scooter Copyright ©2020 ePropulsion All Rights Reserved...
-
Page 2: Important Safety Instructions
Important Safety Instructions Please read this user manual carefully and save it for future reference. 1. Refer all servicing to qualified service personnel. Servicing is required when the product has been damaged in any ways. 2. Do not make unauthorized alterations to the product. Doing so may void the warranty. CAUTIONS 1. -
Page 3: Product Diagram
• SWIMN S1 does not come with a life jacket, and users should wear one when using this product. • If part of the system is damaged, do not use it. Contact your authorized SWIMN dealer or SWIMN customer service instead. - Page 4 • Please use the charger provided, and do not use other charging models. • Please do not charge SWIMN S1 immediately after use. The temperature inside the battery could be high after using and trigger the Over-Temperature Protection. In this status, you cannot use or charge it until the battery cools down.
-
Page 5: Powering On/Off
Note: After starting up successfully, you only need to press one button to keep running. In any emergencies while using SWIMN S1, press the power button for three seconds to shut down the product. The product will switch to Protection Mode with lower motor speed after operating in the air for about five seconds. - Page 6 Operating Splashing 1. Put SWIMN S1 flat on the water surface and lean your body on the board. 1. Install the two provided water gun nozzles by tightening them on clockwise. 2. Press both start buttons to move forward, tilt the board to turn, and release both buttons to stop.
-
Page 7: Product Specifications
Rated Motor Power 250W Rated Voltage 22.2V 1. Stop using SWIMN S1 immediately and shut it down. 2. Place SWIMN S1 in a cooler environment (32 ℉ - Rated Capacity 4400mAh Flashes red once and blue twice Battery temperature is too high 86 ℉... -
Page 8: Product Cleaning
Product Cleaning Propeller Cleaning 1. Soak the product in fresh water after use. 1. Power off the product. 2. Drain the product by placing it vertically. The draining process takes about 30 seconds. 2. Use a Phillips screwdriver to remove the protection fence mounting screws (seven screws in total). 3. -
Page 9: Product Storage
1. Fully charge the battery before storage and recharge every three months to prevent over-discharge for long time of no use. the Warranty Period, at its option and to the extent permitted by law, SWIMN will: (1) repair the hardware defect by using new or 2. -
Page 10: Declaration Of Conformity
Note: This warranty card is not transferrable. Shizheng Tao, Chief Executive Officer & Cofounder of We may charge a repair fee for the out-of-warranty repair. Guangdong ePropulsion Technology Limited For more information, please visit www.swimn.com or contact us at support@swimn.com. - Page 11 Learn more at www.swimn.com Version 2.1...
Need help?
Do you have a question about the S1 and is the answer not in the manual?
Questions and answers