What’s in the Box Kit Components Raspberry Pi 3 Model B+ DIY Case Kit Raspberry Pi Keyboard Raspberry Pi Mouse Note: All components are individually replaceable. Please contact us through Amazon for a replacement. Raspberry Pi Power 32 GB SD Card with HDMI Cable LuluPepper Media LLC Supply Raspbian Operating System DIY Case Kit Components DIY Case ...
Page 4
Build Your Computer ONE Mount Heatsink on Raspberry Pi Computer Remove the protective film from the back (adhesive side) of the heat sink. Mount the heat sink on the Raspberry Pi CPU/SoC chip. TWO Insert the SD Card Insert the SD card into the SD card slot on the back of the Raspberry Pi computer. ...
Page 5
Build Your Computer FIVE Mount the Power Controller Circuit Board Mount the power controller board onto the Raspberry Pi using the 40‐pin GPIO. Make sure that SIX the GPIO pins correctly align with Snap Case Lid into Place the connector on the power Align the case lid so that power controller board and the Micro button is directly over the switch USB port aligns with the “PWR” on the power controller board. case cutout. Note that the power button should opposite the USB and Use the four small screws to network ports. secure the power controller to the Raspberry Pi. Push down gently until you hear the lid snap into place. ...
First Power Up Power on and Update Software ONE Connect to your wireless Click on the wireless icon to connect to your wireless network If you have a wired network, TWO you may also connect your computer with a network Update your system cable. software Open the terminal window and enter two commands to update your system. First: sudo apt update <enter> Once the upgrade is complete, type: sudo apt upgrade <enter> ...