How To Clean - TaoTronics TT-AD002 User Manual

Power Off
When the timer is off, press the Mist Button once to turn off the unit.
Cleaning the Water Tank
・ Unplug the power cord and remove the cover.
・ Drain any reaming water from the tank.
・ Add some warm water into the tank and mix with mild detergent, wash
with a cleaning cloth.

How to Clean

IMPORTANT!
Please unplug the unit before cleaning!
Regular Cleaning
1) Empty the tank from the water outlet.
2) Add 3-5g (approx. one teaspoon, based on scale of the residues)
baking soda / NaHCO3 to the tank.
3) Fill the tank halfway full with warm water (100-150ml / 3.38-5.07floz,
50°C / 122°F), stir it to fully dissolve.
4) Soak for 3-5mins, wipe down the tank and tank cover using a small
brush or soft cloth with baking soda solution. (For better cleaning,
remove the muting cover and wipe it down thoroughly).
5) Drain the solution and rinse the tank under tap water.
6) Rub the inside and outside dry with a dry towel or clean cloth.
7) Wipe off the soda residues if any.
Deep Cleaning
You are recommended to deep clean your diffuser once a month or when
the mist output is low due to grime build-up.
1) Empty the tank from the water outlet.
2) Add 2-3 teaspoons of baking soda / NaHCO3, or 2-3 slices of fresh
lemon to the tank.
03
3) Fill the tank halfway full with warm water (100-150ml / 3.38-5.07floz,
50°C / 122°F), stir it to fully dissolve.
4) Soak for about half an hour.
5) Thoroughly clean the grime at the bottom and atomizer (slot at the
center) of the tank with a small brush.
6) Wipe down tank cover using a small brush or soft cloth with baking
soda solution. (For better cleaning, remove the muting cover and
wipe it down thoroughly).
7) Drain the solution and rinse the tank under tap water.
8) Wipe off the soda residues if any.
9) Rub the inside and outside dry with a dry towel or clean cloth.
Notes:
1) You may use dishwashing detergent when baking soda is
unavailable. But it works better for oil removing instead of odor
and mineral buildup.
2) Do not rinse the base directly with water; try to avoid wetting the
buttons, light holes, air inlets and underneath to avoid short circuit.
3) It is not recommended to clean the unit with white vinegar since
its direct and indirect contact with the atomizer will damage it
permanently.
04