Advertisement
BootROM - 2.03
Starting CP-1 IOROM 1.07
Booting from SPI NOR flash 1 (0x32)
Found valid image at boot postion 0x000
lNOTICE: Starting binary extension
NOTICE: Gathering DRAM information
mv_ddr: mv_ddr-armada-17.02.0-g42da6da (Mar 15 2017 - 13:30:32)
mv_ddr: completed successfully
lBooting Trusted Firmware
BL1: v1.2(release):armada-17.02.0:
BL1: Built : 13:30:36, Mar 15 2017
NOTICE: BL1: Booting BL2
lNOTICE: BL2: v1.2(release):armada-17.02.0:
NOTICE: BL2: Built : 13:30:37, Mar 15 2017
NOTICE: BL1: Booting BL31
lNOTICE: BL31: v1.2(release):armada-17.02.0:
NOTICE: BL31: Built : 13:30:38, Mar 15 2017
l
U-Boot 2015.01-armada-17.02.0-g0f680c8 (Mar 15 2017 - 13:12:27)
Then, U-Boot prints out the system settings and serdes configurations:
I2C: ready
DRAM: 15.8 GiB
Board: MACCHIATOBin-8040
Clock: CPU 1300 [MHz]
DDR 800 [MHz]
FABRIC 800 [MHz]
MSS 200 [MHz]
DDR 64 Bit width
LLC Enabled (Exclusive Mode)
Comphy chip #0:
Comphy-0: PEX0
Comphy-1: PEX0
Comphy-2: PEX0
Comphy-3: PEX0
Comphy-4: KR
Comphy-5: SATA1
Comphy chip #1:
Comphy-0: SGMII1 1.25 Gbps
Comphy-1: SATA0
Comphy-2: USB3_HOST0
Comphy-3: SATA1
Comphy-4: KR
Comphy-5: SGMII2 1.25 Gbps
Both the Single Shot and Double Shot MACCHIATObin boards are programmed to auto
load the kernel and Buildroot file system stored in the on-board eMMC out-of-the-box.
Check the log message on the console during the kernel boot and we will be prompted with
the Buildroot login:
Welcome to Buildroot
buildroot login: root
4/7
Advertisement
