Advertisement
Quick Links
Quick Start Guide
wiki.macchiatobin.net/tiki-index.php
Table of contents
Introduction
This page offers information on how to get a quick start with your MACCHIATObin Single
Shot or the MACCHIATObin Double Shot board, how to boot it for the first time and make
sure everything is working fine. For instructions on how to compile system components and
boot them with your own build binaries, see BSP HowTo.
I/O ports and connectors
First, let us see what ports and connectors are available on the MACCHIATObin
boards. Below is a picture of the MACCHIATObin Double Shot board from top view:
Note
The 10G copper connectors are only available on the Double Shot version of
MACCHIATObin; they are not mounted on the Single Shot MACCHIATObin board.
1/7
Advertisement
Summary of Contents for MACCHIATObin Single Shot
- Page 1 This page offers information on how to get a quick start with your MACCHIATObin Single Shot or the MACCHIATObin Double Shot board, how to boot it for the first time and make sure everything is working fine. For instructions on how to compile system components and boot them with your own build binaries, see BSP HowTo.
- Page 2 For a mode in-detail overview of the on-board DIP switches and the pin out information of the connectors, please see Ports and Interfaces. Prerequisites Here is what you will need to power up the Single Shot or Double Shot MACCHIATObin boards: Linux or Windows PC...
-
Page 3: Serial Connection
USB 3.0 port on the MACCHIATObin. Serial connection Regarding step 2 from above, we will use serial connection to access the console on MACCHIATObin. Follow the tutorial for your OS to make sure you have everything needed: Serial connection - Windows Serial connection - Linux... - Page 4 Comphy-4: KR Comphy-5: SGMII2 1.25 Gbps Both the Single Shot and Double Shot MACCHIATObin boards are programmed to auto load the kernel and Buildroot file system stored in the on-board eMMC out-of-the-box. Check the log message on the console during the kernel boot and we will be prompted with...
-
Page 5: Initial Network Setup
IP address through the Ethernet interface . Connect one end of an Ethernet cable to the RJ45 1GbE port on MACCHIATObin and the other end to your router or IP switch. In the Buildroot shell insert the following commands to configure eth2 interface to... -
Page 6: Usb Interface
= 113.781/114.961/118.081 ms USB Interface There is one USB 3.0 port available on the MACCHIATObin board, your may plug in either USB3.0 stick or USB2.0 stick to this port. Example detection output from Buildroot when a USB3.0 device is plugged in: # [ 87.175751] usb 2-1: new SuperSpeed USB device number 2 using xhci-hcd... - Page 7 BL31: v1.2(release):armada-17.02.0: NOTICE: BL31: Built : 13:30:38, Mar 15 2017 U-Boot 2015.01-armada-17.02.0-g0f680c8 (Mar 15 2017 - 13:12:27) I2C: ready DRAM: 15.8 GiB Board: MACCHIATOBin-8040 Clock: CPU 1300 [MHz] DDR 800 [MHz] FABRIC 800 [MHz] MSS 200 [MHz] DDR 64 Bit width...