Back-To-Back Installation - Tripp Lite BP240V10RT3U Owner's Manual

Mounting

Back-to-Back Installation

Connect the shelved sections from two UPSRMRII kits (A) to the unshelved sections
1
(B) using the included screws and nuts (C). Note: Two unshelved sections will be
left over. Leave the screws slightly loose so that the shelves can be adjusted in the
next step.
Adjust each shelf to fit your rack, then mount them in the lowest available space of
2
your rack with with the screws, nuts and washers provided (D). Note that the support
ledges should face inward. Tighten the screws that connect the shelf segments (C).
Attach mounting ears (E) to the front mounting holes of your equipment (F) using the
3
screws provided (G). The ears should face forward.
Using an assistant if necessary, lift your equipment and slide it onto the mounting
4
shelves. Attach your equipment to the rack by passing the screws, nuts and washers
provided (H) through its mounting ears and into the rack rails.
continued
1
D
2
3
4
4
C
B
F
E
H
A
C
G