Arena Luci BARIO LED User Manual

This instruction manual contains important information
about the installation and use of the projector. Please
read and follow these instructions carefully.
The security of this device is guaranteed only with the
proper use of the following instructions, therefore they
must be kept carefully.
Never install the device in locations easily accessible by
people who ignore the existence of this user's manual
and safety instructions.
Disconnect the unit from any power supply before
attempting any operation in contact or inside the unit, and
when not in use.
It is essential that each device is correctly earthed and
that electrical installation conforms to all relevant
standards. Never supply the unit without the earth link.
Prior to connect the unit to the mains supply, check the
output voltage fits technical requirements on the label.
Never let power cord come into contact with other cables.
Never touch electrical contacts, either directly with your
fingers, or indirectly by means of sharp or metal objects.
Make sure that cables cannot cause trip hazard.
Do not attempt to dismantle and modify the unit.
Due to high technological level of this unit, service
maintenance should be performed by specialised opera­
tors. Please contact your Arena Luci dealer for any issue.
Always ensure that the structure to which you are
attaching the unit is secure and is able to support the
weight of each unit.
Always make sure you are using a safety chain
connected to the unit.
Do not allow contact with water or any other fluids, or
Please note that as part of Arena Luci's ongoing commitment to continuous product development,
specifications are subject to change in the course of product improvement without notice. Arena Luci is not
responsible for damages resulting from improper or different use than expected.
BARIO LED
User's Manual
Profile LED spot with manual zoom and DMX
PRF­0501935D­WW
PRF­0501935D­NW
PRF­0501935D­W
WARNINGS
metallic objects (IP 20).
Do not install the projector in areas of high humidity. The
unit is intended only for indoor purposes.
Avoid installing the unit close to heat sources.
Never lean the power cord on hot unit surfaces.
Allowed to be mounted directly on inflammable surfaces.
Keep a minimum distance of 3m between the device and
the illuminated surfaces.
Avoid direct exposure to the light from the lamp. The light
luminance is harmful to the eye.
Install the unit where it can be easily aerated.
Avoid obstruction of in/out vents.
The lighting apparatus must be used only with its
protective shield.
The protective grill, lenses or ultraviolet filter must be
changed if they are visibly damaged to the point at which
their effectiveness is diminished, for example by
becoming cracked or deeply scratched.
To ensure the reliability of the projector it should be kept
clean. The lens and filters should also be regularly
cleaned (at least once every six months) to maintain an
optimum light output.
Do not use any solvent based cleaning agents. Use only
a soft, dry anti­static cloth.
The installation of LED modules (including power
supplies) should be done according to current technical
rules and regulations. The installation should be
performed only by a qualified operator.
Avoid contact with either corrosive agents or humidity
and moisture on delicate elements: damages from
corrosion are not refunded as component defects.
control