Shaman VDT-01 Manual

Precautions

1) Read these instructions before operating the unit.
2) Please heed all safety warnings and keep these instructions for future
reference. Follow all instructions.
4) Do not use this device near water or moisture.
5) Clean only with dry cloth.
6) Do not install near any heat sources such as radiators, heat registers,
stoves, or other apparatus that produce heat.
7) Only use attachments/accessories specified by the manufacturer.
8) Refer all servicing to qualified service personnel. Servicing is required
when the apparatus has been damaged in any way, such as liquid has
been spilled or objects have fallen into the apparatus, the apparatus has
been exposed to rain or moisture, does not operate normally, or has been
dropped.
9) Battery not included. Use high quality 9V block battery or 9V/DC adaptor
(accessory) for ultimate performance.

Specifications

Shaman VDT-01: Vintage Distortion
Input Impedance: 1 MΩ
Nominal Output: 1,25V
Output Impedance: 1 KΩ
Output Noise Level: <5mV
Controls: Pedal Switch, Gain Knob, Tone Knob, Level Knob.
LED Indicator: On/Off (serves also as battery check indicator)
Connectors: 6.35mm Input jack, 6.35mm output jack,
AC adaptor jack 9V/DC
Power Supply: 9 V DC: dry battery 9V type 6F22/9V, AC adaptor
Current Draw: 4mA @ 9V/DC
Dimensions: 80 (W) x 120 (L) x 35/55 (H) mm
Weight: 280 g (battery not included)

1. DV 9V Input

The VDT-01 can be powered by 9V battery or 9V AC/DC adapter. The adapter must
have a barrel connector with center negative. The battery may be left in or taken out
when using an adapter. To install or replace the 9V battery, loosen the screws on the
bottom and remove the bottom plate. Always remember to unplug your guitar cords
from the pedal to conserve battery life. Some battery drain may take place when unit
is plugged in, even if the unit is bypassed.
Shaman VDT-01 Vintage Distortion
Article no.: 00034448

2. STATUS LED

When the LED is on, the VDT-01 effect is active. When the LED is off, the VDT-01
is in bypass mode. The footswitch engages/disengages the effect.
This jack accepts input signals (coming from a
guitar, some other electric or electronic musical
instrument, or another effects unit).
The INPUT jack also serves as the power
switch. Power is turned on whenever a plug is
inserted into the INPUT jack, and is turned off
when the plug is disconnected. When not using
the unit, you should disconnect any cord
connected to the INPUT jack.

4. OUTPUT Jack

Connect this jack to your amplifier or some
other electric or electronic musical instrument,
or another effects unit.

5. Pedal Switch

This switch turns the distortion effect ON/OFF.

6. Tone Knob

This knob controls the tone of the distortion
sounds. Rotating the knob clockwise cuts lower
frequencies, creating sharp sounds. Rotating
the
frequencies, creating softer, warmer sounds.

7. Gain Knob

This knob controls the depth of distortion sounds and the length of sustained
sounds. Rotating the knob clockwise creates deeper distortion and a longer
sustain time.

8. Level Knob

This knob adjusts the level of the effect sound.
Musikhaus Kirstein GmbH
Bernbeurenerstr. 11 / 86956 Schongau / Germany
Phone: 0049-8861-909494-0 Fax: 0049-8861-909494-19

3. INPUT Jack

knob counterclockwise cuts higher