CleverPet Hub Manual

Separate your dog from the Hub while you set up.
Setting up on a table is ideal.
Prepare your dog to meet the Hub. A dog who is
hungry is more likely to engage. If your dog just ate,
you may want to wait to introduce the Hub.
Lift out the inner liner and remove the wall plug by
bending back one of the cardboard tabs.
Do not plug in the Hub yet!
Quick start video tutorials
at clever.pet/howto
1
OPEN THE FOOD HATCH
Remove the orange silicone seal once and
then put it back. Make sure to seal it
properly.
Tip: Always double-check the seal to avoid
malfunction. malfunction.
Food Dish
Food Tray
4
REASSEMBLE THE HUB
Return the food tray to its place on the Hub's base.
With the orange silicone seal facing upward, reinsert the food pod
by inserting the narrow cone end into the hole, and pushing the
wide end onto the orange latches.
Slide the lip of the dome into the slot in the Hub base, just behind
the middle touchpad, and lower dome down until it clicks into
place.
Insert plug into bottom of Hub, at the back, and secure cord
around cord retainers (refer to illustration).
clever.pet | support@clever.pet

BEFORE YOU BEGIN

GET TO KNOW YOUR HUB

Wait for it...
Get the most out of your CleverPet Hub
by following these simple steps.
2
OPEN PET-SAFE DOME LATCH
Remove the dome from the base. Remove the food
pod. (The food pod can be opened for cleaning. See
tips on reverse side.)
Food Pod
3 3
REMOVE THE FOOD TRAY
It holds the stainless steel food dish. The
tray and dish can be cleaned with soap
and warm water.
Do not power up your
Hub and plug it into the
wall just yet. The app will
tell you when.
Cord Retainer