Summary of Contents for LiSeng technology Living Smart
- Page 1 iving mart IoT GateWay Product Manual SH-GWAYL40A Model No: Rev 1.2 Jun, 2016 Page | 1 IoT GateWay...
- Page 2 Table of Contents Page Package Contents …………………………………………………………… 3 Specifications …………………..…………………………………………….. 4 Product Outlook .……………………………………………………………. 5 Hardware Setup Connection …………………………………………… 8 Page | 2 IoT GateWay...
-
Page 3: Package Contents
Package Contents The package contains the following items I: Living Smart gateway x1 II: USB power cable x 1 (*1) III: Network cable x1 (*1) Note: (*1) Only apply on full set product delivery. Bulk pack delivery with Gateway only. Page | 3 IoT GateWay... -
Page 4: Specifications
Specifications Model Number SH-GWAYL40A 802.11 b/g/n RF Interface Zigbee LL & HA1.2 Protocol RF Output Power +20dBm Antenna Internal Antenna Power Source 5Volts @ 1000mA Ethernet RJ45 10/100Mbps USB2.0 or compatible Operating Temperature -20 to 70C Humidity 95% TH Non-condensing Size 56 x 56 x 18mm (±0.5mm) Dimension... -
Page 5: Product Outlook
Product Outlook Top View WPS Button Page | 5 IoT GateWay... - Page 6 Side View Network Connector DC Power In TBD DC Power in: Use for normal USB output DC adaptor connection (USB power adaptor is not included) Network connector: Connect gateway to router through Network cable USB Port USB Port: This USB port is reserved for further firmware update usage Page | 6 IoT GateWay...
- Page 7 LED Status LED 1 (Orange Color) LED 2 (Blue Color) LED1: (Status Indicator) Orange Color: Gateway is ready to use when this indicator become steady LED2: (Connection Status) Red Color: The LAN line connection is using Blue Color: The Wi-Fi connection is using Page | 7 IoT GateWay...
-
Page 8: Hardware Setup Connection
Hardware Setup Connection – By LAN cable connection 1) Connect the gateway to your home router by using network cable. *The router should be possible connect to Internet 2) Plug in the mini USB power cable to gateway DC in port. (USB Power adaptor is not included) 3) Connect the USB Power cable to USB power adaptor and plug into your wall power socket. (USB Power adaptor is not included) 4) LED 1 lights up and flashing. 5) When gateway system ready, LED 1 steady. 6) Now use your smart phone to join the same router network through the Wi-Fi connection. 7) Once the smart phone joined network, you can control this gateway by using Smart Home App. (You can configure the LAN cable connection to Wi-Fi connection late on through the Smart Home App) Page | 8 IoT GateWay... - Page 9 FCC Caution: This device complies with Part 15 of the FCC rules and Industry Canada license-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.