BWI Eagle AIR-EAGLE SR PLUS 36-4500 Product Information Bulletin

AIR-EAGLE
2.4 GHz RF Repeater
MODEL 36-4500
DESCRIPTION
The A -E SR PLUS RF R
IR AGLE
RF signal from any Air-Eagle SR or SR PLUS Transmitter. When
placed in an area where the signal is weak, this unit will then re-
transmit at full strength facilitating greater distances and allowing the
RF signal to reach around corners, through tunnels, over hills and
through valleys.
APPROVALS
United States (FCC)
Canada (IC)
Europe (CE)
INSTALLATION
DISCONNECT AC Power from all equipment before installation.
1. Mount the A -E SR PLUS R
IR AGLE
2. Install antenna. The unit has an antenna connector located on the
right side on the enclosure. Attach the supplied portable antenna to
this connector.
3. Connect AC power and control to the proper terminals in your control
circuit.
TERMINAL STRIP WIRING
1 Not Used 7 Not Used
2 Not Used 8 Not Used
3 Not Used 9 Not Used
4 Not Used 10 Not Used
5 Not Used 11 Not Used
6 Not Used 12 Not Used
238 Pillow Street
Butler, PA 16001
724-283-4681
724-283-5939 (fax)
www.bwieagle.com
®
SR PLUS
designed to retransmit an
EPEATER IS
OUR-XBEEPRO
4214A-XBEEPRO
ETSI
in a convenient location.
EPEATER
13 120 VAC - (Neutral)
14 120 VAC - (Hot)
PRODUCT INFORMATION
BULLETIN
Dimensions (with mounting plate) 6.3" L x 4.8" W x 2.3" H
CONTROLS AND INDICATORS
-
INPUT
+
T1
PWR1
C1
C2
LED1 LED2
REL1 REL2
FET1 FET2
TER1
|
N/O C N/C N/O C N/C
|
1
MOV1
Yellow LED illuminates as remote signals are
RX LED
being received by the repeater
Green LED is illuminated while power is applied
POWER LED
to the repeater
Red LED illuminates as remote signals are
TX LED
being re-transmitted by the repeater
RF module that receives data from the remote
RF1
transmitter
SEL1 – 4
Not used on this model
SEL5 – 6
Used to set frequency
BP2
-
RF1
OUT
+
IC1
+
C3
VR1
3.3V
LED3 LED4
REL3 REL4
FET3 FET4
SEL1
| | |
N/O C N/C N/O C N/C - +
| | |
2 3 4
AC/DC INPUT
MOV2 MOV3 MOV4
.
BP1