QVC MYSafe 911 Instructions

ALARM SETUP
Insert batteries (included) into
battery compartment per diagram.
Press right side battery check
button for 2 seconds. Front LED light
will temporarily light green if
batteries are ok. LED light will light
red if batteries are low. If the LED
light is not on, recheck the position
of the batteries and repeat until
green or red light is on.
ALARM OPERATION
A
To call 911, press and hold the call
button for (front button with large +
symbol) 5 seconds until you hear
the device say CALLING 911 and
the LED light will show blue. The
device will connect to 911 operator.
If call fails to go through, you will
hear DISCONNECTED, REDIAL
and device will retry calling 911
until an operator can be reached.
B
To disconnect, press left side
CANCEL button or wait for operator
to hang up. Once disconnected
blue LED light will turn off.
NOTE
This device is designed to call 911 ONLY.
It is recommended to check battery every 2 weeks. Front LED light will light red if batteries need to be
replaced. Replace with AAA batteries.
This unit does not provide location. Please let the operator know your exact location. Additionally, this
unit does not allow for call backs and will appear as an unregistered device to the 911 operator.
INSTRUCTIONS
+
BATTERY
Compartment
A
CALL
Button
LED LIGHT INDICATORS
Blue LED Light = Call in progress
Green LED Light = Battery good and device
in standby mode for calling 911
Red LED Light = Batteries low. Replace
batteries.
BACK
Battery
Compartment
LED Light
FRONT LEFT
SIDE
BATTERY
CHECK
Button
Battery
Compartment
RIGHT
SIDE
B
CANCEL
Button