Toshiba Satellite 2410 Series Resource Manual page 11

9 Gently press down on the memory module connector until the clips
snap into place.
Do not force the module into position. The memory module should be
level when secured in place.
Inserting the memory module
CAUTION: Avoid touching the connectors on the memory module or on the computer.
Grease or dust on the connectors may cause memory access problems.
10 Replace the memory slot cover.
11 Replace the screw and tighten them.
12 Turn the computer over and reconnect any cables you removed.
You can now continue setting up the computer. When the operating system
has loaded, you can verify that the computer has recognized the additional
memory.
If you are adding extra memory after setting up the computer, verify that
the computer has recognized it correctly as described in "Checking total
memory."
Removing a memory module
CAUTION: If you use the computer for a long time, the memory modules will become
hot. If this happens, let the modules cool to room temperature before you replace them.
1 Follow steps 1 through 6 in "Installing additional memory (optional)"
on page 9.
CAUTIONS: Do not try to remove a memory module with the computer turned on. You
can damage the computer and the device.
Do not remove the memory module while the computer is in Standby mode.
The computer could hang up the next time you turn it on and data in memory will be
lost. In either of the above cases, the Standby configuration will not be saved.
The following message appears when you turn on the power:
Warning: Resume Failure
Press Any Key To Continue
If the computer hangs up when you turn it on, perform the following: Press the power
button and hold it down for five seconds, then turn the power on again.
Setting up your computer and getting started
11