Summary of Contents for BabyGo Magnetic Safety Lock
- Page 1 Magnetic Safety Lock Instructions Extra Strong Adhesive No screws or drilling required 10 Locks 2 Keys babygo.uk...
-
Page 2: Child Safety
Thank you for choosing BABYGO Our easy to install, magnetic child safety cupboard locks, give you the confidence to allow your child to explore their surroundings, as they begin to take their very first steps at home. These locks work on high quality cupboard doors and drawers, up to 38mm (1.5”) thick, helping to protect your child from injury and preventing your... -
Page 3: Box Contents
How To Install Install your child safety lock in less than 30 seconds by reading our simple to follow step by step guide. Or visit www.babygo.uk and watch our easy to follow installation video guide. Languages Visite https://www.babygo.uk/lock-manual-es para instrucciones en español Per favore visita https://www.babygo.uk/lock-manual-it... - Page 4 Dual Setting Locks Your locks [a] are complete with two settings, active and de-active. Flick the hook upwards to activate the lock mechanism. Flick the hook downwards to deactivate the lock mechanism. When the hook is set to close your cupboards will function as normal. Top Tip Deactivate your lock for convenience when your little ones are not around! Safety Lock Position...
- Page 5 How to Install Your Safety Lock [7 Steps] Step 1: Push your safety catch [d] into your applicator [c] Ensure the 3M tape is facing outwards. Step 2: Push your dual setting safety lock [a] into your applicator [c] Ensure the 3M tape is facing outwards.
- Page 6 How to Install Your Safety Lock [7 Steps] Step 5: Close your door or drawer for 3 seconds. Step 6: Open your door or drawer and for best results: • Remove the applicator [c]. • Apply firm pressure for 3 seconds, to your dual setting safety lock [a].
- Page 7 Use the tape, on the back of your twist and release holder and attach your key to a high place. Support For help and advise on installation email help@babygo.uk. Alternatively, see solutions to common questions overleaf.
- Page 8 Q. My safety locks are not sticking strong enough? Remember to apply significant pressure. After application, the bond strength will increase as the adhesive flows onto the surface. At room temperature approximately 50% of ultimate bond strength will be achieved after 20 minutes. 90% after 24 hours and 100% after 72 hours.