Friant FMA-D Installation Manual

4 3
2
5
13
CLAMP
6
Step 2A: Clamp Option
1
1
4
C
F
Use supplied allen wrench
to attach to bottom
support clamp with M6x
12mm screws (3).
Step 2B: Grommet Option
1
8
7
Insert screw into bottom support
grommet. Use allen wrench to
attach bottom support grommet
to monitor arm by using M6x
16mm screws (3).
DUAL
MONITOR ARM
Parts:
1. Dual monitor arm (1)
2. cable cover (1)
3. anti-slip rubber clamp (1)
4. bottom support clamp (1)
5. anti-slip rubber clamp (4)
6. knob (1)
7. bottom support grommet (1)
7
8
9
Step 1:
10
Make sure there are VERSA holes
11
(100 x 100mm or 75 x 75mm). Then,
GROMMET
remove the original fixed base of the
monitor. Make sure you are careful
12
not to scratch the monitor screen.
VERITY
C D F x1
x3 x2
4X4
2
3
Attach anti-slip
rubber clamp to
the bottom of the
monitor arm.
C F x1
x3
4X4
2
1
C
F
Attach monitor arm to desk, by
inserting the base with the screw
into the predrilled hole. Before you
merge your monitor arm and your
desk, make sure you are using the
anti-slip rubber grommet.
3
D
F
Using the allen wrench, attach
the knob to the bottom
support using M6x 10mm (2)
screws. Place anti-slip rubber
on top of the installed knob.
3
9
10
Size of the hole:8.5-70mm
INSTALLATION
8. screw (1)
9. anti-slip rubber grommet (2)
10. pressure plate (1)
11. knob nut (1)
12. bottom support verity (1)
13. block verity (2)
100 75
4
5
6
D E S K
Ti ghten
Insert desktop in the gap
between the monitor arm
and the bottom support.
Place the cable cover over
exposed cables.
3
11
Ti ghten
Attach anti-slip rubber grommets
(2) to the pressure plate. Attach
the pressure plate to the bottom
of the worksurface by screwing
everything together with the
knob nut.
A B C D
x4 x4 x3 x2
M4x12mm M5x12mm M6x12mm M6x10mm
F G x1 H x1
x8
4X4 5X5
C D F x1
x3 x2
75
4X4
100
NOTE
Fits worksurface
thickness:
3/4" - 4"
Fits worksurface
thickness:
3/4" - 4"