ESTATE
®
PULL-DOWN KITCHEN
FAUCET
Thank you for selecting American Standard...
the benchmark of fine quality for over 100 years.
To ensure that your installation proceeds smoothly-please read
these instructions carefully before you begin.
RECOMMENDED TOOLS
Flat Blade Screwdriver
1
INSTALL FAUCET WITH OR WITHOUT DECK ESCUTCHEON
• (A) Installation less ESCUTCHEON (1). Make certain the SEAL (9) is properly seated in recess of faucet body. Insert
supply HOSES (2), SPRAY HOSE (7) and SHANK (3) through mounting hole and seat SPOUT BASE onto sink or
mounting surface. Do not use putty.
• (B) Installation with ESCUTCHEON (1 Optional). Apply a bead of putty to bottom edge of ESCUTCHEON with
PUTTY PLATE (1). Make certain the SEAL (9) is properly seated in recess of faucet body. Insert SUPPLY HOSES (2),
SPRAY HOSE (7) and SHANK (3) through hole of ESCUTCHEON with PUTTY PLATE (1) and mounting surface. Follow
mounting instructions below to secure faucet to mounting surface.
• Insert HOSES (2) through RUBBER WASHER (4), BRASS WASHER (5), and threaded LOCKNUT (6).
• Assemble RUBBER WASHER (4), BRASS WASHER (5), and threaded LOCKNUT (6) onto SHANK (3) from underside
of sink or mounting surface. Hand tighten LOCKNUT (6).
• Use a screwdriver to tighten SCREWS (8) on LOCKNUT (6). Work your way around LOCKNUT (6), tightening the
screws slightly each time until all are snug to ensure even pressure.
Product names listed herein are trademarks of AS America, Inc.
© AS America, Inc. 2018
Phillips Screwdriver
7
B (Optional)
SPOUT BASE
9
2
3
7
4
5
6
8
INSTALLATION
INSTRUCTIONS
4968.300
4968.305
Adjustable Wrench
CAUTION
A
SPOUT BASE
1
PUTTY
SINK OR
MOUNTING
7
SURFACE
5
6
- 1 -
Certified to comply with ANSI A112.18.1M
Certified to comply with ANSI A112.18.1M
Plumbers' Putty or Caulking
Turn off hot and cold water
supplies before beginning.
7
9
3
2
4
8
M965743 Rev. 1.1 (11/18)