Advertisement
Quick Links
BLG-LEDBLT-SP131
18 Watt LED Replacement Engine for BLG-LEDBLT-HGL
Thank you for your purchase of the 18 Watt LED Replacement Engine for BLG-LEDBLT-HGL, the following instructions
are intended for this part number only.
REPLACEMENT:
To install the new LED Light, remove all fasteners securing the old LED in
place. Remove the screws holding the protective LED housing onto the
light to remove the housing. Loosen or take out the two bolts on each side
of the top of the tightening clamp in order to free the LED. Remove the
old LED and put the new one in its place, tighten the bolts on the clamp
and reinstall the protective housing around the front of the LED.
Larson Electronics, LLC
Instruction Manual
Phone: (800) 369-6671
Wiring and
Plug: This replacement LED engine comes equipped with
an 18" whip cable that is terminated in a Deutsch connector.
Simply plug in the connector from the light to the female
Deutsch connector.
Fax: (903) 498-3364
www.larsonelectronics.com
Part # BLG-LEDBLT-SP131
1 of 2
Advertisement
Summary of Contents for Larson Electronics BLG-LEDBLT-SP131
- Page 1 Part # BLG-LEDBLT-SP131 BLG-LEDBLT-SP131 18 Watt LED Replacement Engine for BLG-LEDBLT-HGL Instruction Manual Thank you for your purchase of the 18 Watt LED Replacement Engine for BLG-LEDBLT-HGL, the following instructions are intended for this part number only. REPLACEMENT: To install the new LED Light, remove all fasteners securing the old LED in place.
- Page 2 Part # BLG-LEDBLT-SP131 Safety Warnings For personal safety, always follow the safety instructions in this manual to ensure safe and long- term use. Failing to do so can result in damage to the product or serious bodily injury Warnings To prevent serious damage to eyesight, never look into spotlight when light is on.