Solatube Brighten Up Series
Solatube 160 DS
Solatube Base Kit
*
Items marked
comprise the
Solatube base kit which is
suitable for installations with
a roof to ceiling distance of
up to 400mm. For distances
greater than this, extension
tubes will be required –
please see chart right.
*
Seal & fastener kit
▪ Flashing sealant
▪ Roll aluminium tape
▪ Flashing screws
▪ Dome ring screws
▪ Tube screws
(15mm)
▪ Ceiling flange screws
▪ Expansion joint seal
▪ LightTracker™ dome reflector
(use reflector only on steep, north facing
roofs or wall-mounted installations)
(250mm diameter)
Product Installation Guide
*
Roof dome with
Raybender
*
*
Top tube
assembly
(with integral
adjustable angle)
(not shown)
(if specified)
(53mm)
(35mm)
*
(40mm)
fixture/ Diffuser
and natural effect lens
Solatube 290 DS
&
3000
®
Technology
Roof flashing
(as specified,
supplied with
flashing insulator)
Extension tubes
610mm long
(quantity as specified)
*
Bottom tube
assembly
(with integral
adjustable
angle)
Decorative
(350mm diameter)
Please read this guide
fully before beginning
installation
Additional extension tubes?
You will receive a top tube and bottom
tube assembly in your Solatube Base
Kit. Together these assemblies give a
tube length (roof to ceiling) of up to
400mm (16"). This is generally sufficient
for flat roofs, vaulted ceilings, or very
shallow pitch roofs. For longer tube
lengths please check you have
purchased sufficient extension tubes to
meet your required install distance:
Tube length
Extension
up to mm (inches)
tubes req
400 (16")
960 (38")
1520 (60")
2080 (82")
2640 (104")
3200 (126")
3760 (148")
4320 (170")
Please ensure that all components have
arrived in perfect condition before
starting the installation
0
1
2
3
4
5
6
7
Need help?
Do you have a question about the Brighten Up Series and is the answer not in the manual?
Questions and answers