Samsung MRK-A10N User & Installation Manual page 5

Receiver & Display Unit Installation
Accessories
Receiver & display
unit (1)
1
Remove the receiver & display unit cover by using the
tab on its bottom.
2
Open the receiver & display unit.
3
Connect the end of the connector wire to the receiver
& display unit and connect the other end of the wire to
the DISPLAY connector of Indoor PCB as shown in figure.
‹ X Do NOT keep the receiver & display unit cable with a
220V cable because the remote controller cables have
low voltage.
4
Secure the receiver & display unit on the wall with
two screws.
5
Reassemble the receiver & display unit cover.
‹ X The receiver & display unit must be installed by an
installation specialist.
‹ X Before installing the receiver & display unit, ensure that
you have turned off the main power.
‹ X All receiver & display unit cables should be installed
according to the national wiring rules and you must install
it in the wall not to be touched by users.
SOL Receiver & Display Unit_IBIM_EN_DB68-03717A-05.indd 5
PH, +, 2, M2, L10 TH, +, 1, M4, L20
tapped screw (4) tapped screw (2)
User & Installation Wire kit [Length:
Manual (1) 10m (32.80ft)]
Receiver &
display unit
5
EN-
2016-05-12 오전 11:21:53