1. Manuals
  2. Brands
  3. Clare Controls Manuals
  4. Home Automation
  5. ClareOne CLR-C1-PNL1
  6. Release notes

Clare Controls ClareOne CLR-C1-PNL1 Release Notes

Wireless security and smart home panel
Hide thumbs

Advertisement

Table of Contents

ClareOne Wireless Security and Smart Home
Panel Release Notes
Content
Last modified: 03/10/20

Introduction

The ClareOne Wireless Security and Smart Home Panel (CLR-C1-PNL1) is a
smart home hub featuring customizable home automation and security control.
The ClareOne eliminates the need for separate control and customization
devices.
Figure 1: ClareOne Panel - front
(1) Camera
(2) IR sensors (2 on each side)
DOC ID - 1896 • Rev 01 • DRAFT 00.08
(3) Microphones (on each side)
(4) LED
1 / 10

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the ClareOne CLR-C1-PNL1 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Clare Controls ClareOne CLR-C1-PNL1

  • Page 1: Table Of Contents

    ClareOne Wireless Security and Smart Home Panel Release Notes Content Introduction...1 Installing the panel...3 ClareOne setup...7 Known issues...10 Contact information...10 Last modified: 03/10/20 Introduction The ClareOne Wireless Security and Smart Home Panel (CLR-C1-PNL1) is a smart home hub featuring customizable home automation and security control. The ClareOne eliminates the need for separate control and customization devices.
  • Page 2 Figure 2: ClareOne Panel - exterior rear (1) Tamper button (6) DC routing hole #1 (2) Back plate secure screw (7) DC routing hole #2 (3) Rear panel cover (8) LAN routing hole (4) Mounting holes (9) Siren routing hole (5) Siren Figure 3: ClareOne Panel - interior rear (1) DC wiring terminal...

  • Page 3: Installing The Panel

    Installing the panel Only qualified installation technicians should install the panel. Clare Controls does not assume responsibility for damages caused by improper installation, connection to the network, or use of the device. Installation options Select an installation option and powering method. The panel can be powered by the provided power supply or using a 12 VDC (3A) direct connection.
  • Page 4 3. Verify that the battery is plugged in, and then attach the power supply to the panel. Note: For other power options, see ClareOne Wireless Security and Smart Home Panel User Manual (DOC ID 1871). 4. Attach the panel’s back cover, gently pressing it into place. Verify that the tabs are both fully pressed in.
  • Page 5 9. (Optional) The viewing angle of the panel can be adjusted by pressing the tab in on the kickstand and sliding the base up or down to the desired position, locking it into place. Installation option 2: Wall mounted Option 2 uses the included wall mount bracket. The recommended height for mounting the panel is 48 in.
  • Page 6 b. Mounting hole: Mark the locations of the 4 holes in the wall mount bracket on the wall, be sure to keep the bracket level when marking the locations. Using a power drill with 5mm bit, drill a hole at each location.

  • Page 7: Clareone Setup

    8. Press the panel onto the mounting bracket, and then slide the panel down until it locks into place. 9. Plug the opposite end of the power supply into an electrical outlet. The panel automatically powers up. Note: Do not connect to a receptacle controlled by a switch. ClareOne setup Once the panel is installed in the desired location and is connected to a power source, setup the ClareOne panel.
  • Page 8 3. Select your time zone from the drop-down, and then tap Save. Notes • ClareHome uses the location of the device for timers and events. • Tap <- Back to return to the previous step/screen. 4. Scroll and tap to select the desired network, enter the password, and then tap Note: to hide the keyboard.
  • Page 9 a. Tap Set Installer PIN, and then enter the desired 5-digit PIN. b. Verify the PIN, and then tap Next. You are returned to the Set PIN page. c. Tap Set Master PIN, and then enter the desired 4-digit PIN. d.

  • Page 10: Known Issues

    The panel announces that there is Ethernet trouble during the wizard. 1390 Schedules using the astrotimer set to x minutes before sunrise/sunset do not execute. Contact information Clare Controls, LLC. 7519 Pennsylvania Ave, Suite 104 Sarasota, FL 34243 General: 941.328.3991 Fax: 941.870.9646 www.clarecontrols.com...

Table of Contents