Related Manuals for Entel RP500 Series
Summary of Contents for Entel RP500 Series
- Page 1 Radio Communications Supply & Installation Specialist Website www.radiotronics.co.uk Email sales@radiotronics.co.uk Telephone Numbers 0345 0 955 955 02087 190 180...
- Page 2 RP series programmer files. Entel RP500 Series Repeater. Entel CPROG RP Repeater Programming Lead. To place a repeater into programming mode: Ensure the repeater is turned off. Ensure the "Talk‐Through On / Off" button on the front panel of the repeater is set to on, so that the button is in the "out" position. Connect the programming lead between your PC and the Repeater. © REF: ED029 Page: 1 / 3 Copyright Entel UK 2012 All Rights Reserved...
- Page 3 While pressing & holding the button on the programming lead turn on the base station. Release the switch on the programming lead. Push in the talk through button on the front panel of the repeater. The repeater will now be in programming mode, this will be indicated by the Red TX LED on the front panel of the repeater flashing on/off and the Green RX LED constantly glowing. © REF: ED029 Page: 2 / 3 Copyright Entel UK 2012 All Rights Reserved...
- Page 4 Disclaimer Information in this document is subject to change without notice. The manufacturer does not make any representations or warranties (implied or otherwise) regarding the accuracy and completeness of this document and shall in no circumstance be liable for any loss of profit or any other commercial damage including but not limited to special, incidental, consequential or other damage resulting from the use of this document. © REF: ED029 Page: 3 / 3 Copyright Entel UK 2012 All Rights Reserved...