Summary of Contents for Eding CNC CPU5B
- Page 1 XHC Wireless Pendant Manual User Manual 3D Print Interface CPU5B Document Release 1.00 10 November 2016...
- Page 2 XHC Wireless Pendant Manual Published by: Bert Eding Eindhoven The Netherlands Title: Manual 3D printing interface CPU5B Author: Bert Eding Date: Thursday, 10 November 2016 Document History Version Date Author Comment 04-01-2016 Bert Eding Initial version © Copyright Eding CNC Holding B.V.
- Page 3 Introduction and intended use ....................4 Operating instructions ..........................5 Installing the interface ....................5 2.1.1 Connections to 3D printer......................5 2.1.2 Connections to CPU5B ........................5 2.1.3 Thermocouple ..........................6 2.1.4 Voltage to temperature translation ....................6 10 November 2016...
- Page 4 XHC Wireless Pendant Manual 1 Introduction and intended use The MPG 3d printing interface is used for: Temperature measurement Extruder Temperature measurement Heat bed Heating control Extruder Heating control Heat bed Workpiece FAN control 10 November 2016...
- Page 5 Connections to CPU5B 1. Connect 20 Pole flat cable to OUT connector of CPU5B 2. Connect 10 pole flat cable to IN3 connector of CPU5B (Text IN-1 on interface board is wrong). The extruder thermistor is connected to ANALOG 1 of the CPU and the Heat bed thermistor to ANALOG 2, you can see the analog value read in the IO screen of the software.
- Page 6 XHC Wireless Pendant Manual 2.1.3 Thermocouple The board is standard designed to use 100K thermistors, these are sold by most 3D printer equipment suppliers. A thermocouple for the extruder temperature may give better temperature readings/control-performance for the extruder. This is a thermocouple board from reprapworld. It can be connected to the thermistor input after removal of R7.
Need help?
Do you have a question about the CPU5B and is the answer not in the manual?
Questions and answers