M-system CNT Series Instruction Manual

INSTRUCTION MANUAL
CONNECTOR TERMINAL BLOCK

BEFORE USE ....

Thank you for choosing M-System. Before use, please check
contents of the package you received as outlined below.
If you have any problems or questions with the product,
please contact M-System's Sales Office or representatives.
■ PACKAGE INCLUDES:
Connector Terminal Block ..................................................(1)
■ MODEL NO.
Confirm that the model number described on the product is
exactly what you ordered.
■ INSTRUCTION MANUAL
This manual describes necessary points of caution when
you use this product, including installation, connection and
basic maintenance procedures.

POINTS OF CAUTION

■ GENERAL PRECAUTIONS

• Before you remove the unit or mount it, turn off the out-
put signal for safety.

■ ENVIRONMENT

• Indoor use
• When heavy dust or metal particles are present in the
air, install the unit inside proper housing with sufficient
ventilation.
• Do not install the unit where it is subjected to continuous
vibration. Do not subject the unit to physical impact.
• Environmental temperature must be within -5 to +55°C
(23 to 131°F) with relative humidity within 30 to 90% RH
in order to ensure adequate life span and operation.

■ WIRING

• Do not install cables close to noise sources (relay drive
cable, high frequency line, etc.).
• Do not bind these cables together with those in which
noises are present. Do not install them in the same duct.

COMPONENT IDENTIFICATION

■ REAR VIEW

INSTALLATION

Refer to the External Dimensions. The CNT-M can be
mounted on a DIN rail.

■ DIN RAIL MOUNTING (CNT-M)

Position the black hook
at the rear side on the
DIN rail and push in
the yellow hook (DIP
rail
removing, push down
the DIN rail adaptor
utilizing a screwdriver
(–) and pull.
5-2-55, Minamitsumori, Nishinari-ku, Osaka 557-0063 JAPAN
Phone: + 81 ( 6 ) 6659-8201 Fax: + 81 ( 6 ) 6659-8510 E-mail: info@m-system.co.jp
MODEL
Body
Body
Model No.
Identification
CNT-S
CNT-S
Specification
adaptor). When
cnt
CNT
Model No. Label
CNT-M
Specification
CNT-M
DIN Rail
35mm wide
Spring Loaded
DIN Rail Adaptor
EM-9232 Rev.2 P. 1 / 2