HALO
HALO
®
C7142, C9242, C9257, and C9170
Commercial Recessed Compact Fluorescent Rough-In
Installation Instructions
Socket
White
White
Yellow
Black
White
Ballast
Green
Line
CAUTION: To avoid possible electrical shock, be sure that power supply
is turned off before installing or servicing this fixture.
Note: This fixture should be supported by main runners or other structure
that is capable of supporting fixture weight of 10 lbs.
To Install Rough-In Section
Step 1
Install fixture into ceiling cavity using 1/2" electrical conduit, 3/4"
channel, 1 1/2" channel, 1/8" x 1/2" bar stock, or T-bar
fasteners as mounting rails (furnished by others) by inserting
them through hanger brackets at both ends.
Step 2
Adjust hanger adjustment screws so bottom of plaster ring is
flush with finished ceiling line. Hanger bracket is reversible for a
total adjustment of 5".
Step 3
Remove one of the junction box covers. Connect supply lead
wires to lead wires of ballast per wiring diagram and in
accordance with your local electrical code(s) or N.E.C.
To Install Trims
Step 1
Attach trim to socket assembly with (2) thumb nuts.
Step 2
Attach trim assembly to center stud with thumb nut.
Yellow
Customer First Center 1121 Highway 74 South Peachtree City, GA 30269 770.486.4800
Socket
Red
Blue
Blue
Ballast
To Clean Trims
Step 1
Gently wipe with a soft, clean, dry lint-free cloth to remove dust.
Step 2
Wipe with a mild detergent solution on a soft, clean cloth to
remove fingerprints and stains.
Step 3
Rinse with clean, soft water and dry with lint-free cloth.
Note for Wall Wash Installation
Housing is to be installed with Side A facing the wall. Wall wash trims can
be oriented with stepped reflector facing wall.
Wall Wash Diagram
Socket
Red
White
White
Yellow
Black
Black
White
White
Ballast
Green
Green
Line
F A X 770.486.4801
Yellow
700267