Profi Care PC-HSM/R 3013 Instruction Manual page 33

• After initial use, do not charge the battery for longer than
10 hours at one time.
CAUTION:
After 10 hours always disconnect from mains power
supply.
NOTE:
You can extent the lifetime of the rechargeable battery by
following these steps:
• Only charge after the battery is nearly exhausted.
• Do not charge for more than 10 hours.
• Charge the appliance at temperatures between 0 °
and + 40 °C.
• In case the rechargeable batteries are faulty, replace
them with two new ones of the same types. Observe the
details under "Technical Data".
Using the Appliance
Switching On and Off
Slide the switch to turn the appliance on or off.
Adjust Cutting Length
1. Turn off the appliance. "ON" can be seen on the switch.
2. Select a comb attach-
ment. The comb attach-
ments are labelled with
numbers.
3. Attach the desired
comb: Also refer to fig-
ure B on page 3. Slide
the blades of the clipper
head into the jags of the comb.
4. To remove the comb attachment, pull it off the clipper
head.
WARNING:
• Switch off the appliance before cleaning. Disconnect the power
adapter from the electrical outlet.
• Do not submerge the appliance in water!
• Do not immerse the power adapter in water!
CAUTION:
• Also do not clean the appliance under running water!
The electronics could get damaged.
• Do not use a wire brush or other abrasives.
• Do not use sharp or abrasive cleaning agents.
PC-HSM-R3013_IM
Cutting length
Number
in mm
1 approx. 4
2 approx. 10
3 approx. 14
4 approx. 18
Cleaning
Cut Hair and Beard
WARNING: Risk of injury!
Do not press the shaving head of the hair / beard trimmer
too firmly against the skin.
NOTE:
• Only cut dry hair with this appliance.
• Start by using the biggest comb attachment and cut
your hair / beard step by step to the desired length.
1. Select the cutting length with a comb attachment.
2. Turn the appliance so that you are able to see the back.
Set the switch (2) to the left position.
3. Switch the appliance on. "OFF" can be seen on the
switch.
Thinning out Your Hair
This appliance has a thin-out function.
• Use the appliance with a comb attachment.
• The different positions of the switch (2), you will be able
to produce different results.
Outlining and Shaving the Neck
• Use the appliance without a comb attachment.
• Set the switch (2) to the left position.
• The shaving head allows for precisely outlining the
beard contours, as well as a clean shaving of the hair
line at the neck.
Finish Operation
Turn the appliance off.
• Use the cleaning brush to remove remaining hair after
use.
• Clean the casing with a slightly damp cloth, if necessary.
• Always clean the power adapter with a dry cloth.
• Regularly apply 1 - 2 drops acid-free oil onto the blades
of the clipper head.
33
11.01.18