Advertisement
Cut out the canopy transparent section using the mark line, glue it onto the epoxy frame, trim it
then and grind a bit off to a desirable shape.
The canopy is held in place with a pin and canopy lock. Bore then the matching holes in the
fuselage and in the canopy frame. Glue the pin in the front canopy frame. Glue the canopy lock
in the fuselage.
Lock
Pin
5. How to install the aileron servos
Install the extension servo cables into the wing. Connect the extension cables to the servos
(connectors or soldering -in this case isolate the wires using the heat shrinking tube). Attach the
control horns to the ailerons. Fix the ailerons in the neutral position using pieces of a self-
adhesive tape. Install single levers to the servos, adjust them to the neutral position and insert the
servos into the holders - without fixing them now. Prepare 2 rods made of 1mm diameter wire
with „Z"- bend on one end ,measure and cut the wires to the proper lengths and solder the brass
endings. Screw in the clevises. Remove the servos, insert the „Z"-bend into the servo lever, and
fix the servos in the holders using a quality double-side self adhesive tape or 5-min. epoxy.
Connect the pushrods to the control horns. Attach the servo covers using a double-sided self
adhesive tape.
6. How to install the servos to the brakes
Advertisement
