Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for MCS MCS-8
Summary of Contents for MCS MCS-8
- Page 1 MCS-8 INSTALLATION GUIDE...
-
Page 2: Table Of Contents
Lin Bus (Con5) ........................7 3.1.5) CAN Bus (Con6) ....................... 7 NOTE: For compatibility reasons, adapters that plug into the MCS-8 CAN Bus (Con6) Connector are typically 6 way. These are designed to fit into the 8 way connector............7 3.1.6) RS485 (Con7) ........................ -
Page 3: Pre-Installation & Required Tools
MDX00008 MCS-8 Installation Guide 1V3 1) Pre-Installation & Required Tools Crimping Tools 1.1) CTX64 Receptacle 6A Female Pin Crimp Tool Molex part number: 63819-3800 http://www.digikey.co.uk/ Part Number: 0638193800-ND http://www.mouser.co.uk Part Number: 538-63819-3800 http://www.ttieurope.com Part Number: 63811-1000 Universal Molex Crimp Tool. (Can be used for all connectors) Molex part number: 0638111000 ... -
Page 4: Mounting
MDX00008 MCS-8 Installation Guide 1V3 Mounting 4 x M4 holes are supplied for mounting the unit to a base panel. Page 4 of 10... -
Page 5: Wiring
MDX00008 MCS-8 Installation Guide 1V3 Wiring Power In and I/O’s 3.1) Speaker Outputs (CON1) Name Function Low output to an 8 or 11 ohm speaker Low output to an 8 or 11 ohm speaker High High output to an 8 or 11 ohm speaker... -
Page 6: 3) Auxiliary I/O's (Con4)
MDX00008 MCS-8 Installation Guide 1V3 3.1.3) Auxiliary I/O’s (CON4) Name Function Supply High Power Outputs Output 1 Programmable Positive Switching Output Secondary Batt Bank A Output 2 Programmable Positive Switching Output Primary Batt Output 3 Programmable Positive Switching Output Secondary Batt... -
Page 7: 4) Lin Bus (Con5)
CAN 2 Low Mic in Audio in from handset NOTE: For compatibility reasons, adapters that plug into the MCS-8 CAN Bus (Con6) Connector are typically 6 way. These are designed to fit into the 8 way connector. 3.1.6) RS485 (Con7) -
Page 8: 7) Usb (Con8)
MDX00008 MCS-8 Installation Guide 1V3 12VDC 12V Supply Output 1000mA Max. PTT Sw PTT Active Low. 3.1.7) USB (Con8) 4) Diagnostics POWER / Red (Steady): Device in use, normal power mode. STANDBY Red (Flashing): Over Temperature. Amber: Device idle, ready for low power mode. -
Page 9: Volume Setting
(or near to) the primary battery terminal. 6.3) DO NOT obstruct fan vents along the top, side or under surfaces of the MCS-8. Do not install any equipment on top or underneath the MCS-8. The above installation requirement must be followed for safe operating and extended product... - Page 10 MDX00008 MCS-8 Installation Guide 1V3 Page 10 of 10...
Need help?
Do you have a question about the MCS-8 and is the answer not in the manual?
Questions and answers