Sound Projections OPT-500 User Manual

Remote Control Func ons Only
IR remote can only be controlled when standing behind speaker facing BT unit
VOL bu ons will control volume of BT/USB player from 0-30.
NOTE: Factory preset (recommended) volume is set at 30,
with all adjustments done with BT/USB Volume on rear panel.
All Func ons below work with USB or SD card ONLY.
To program MP3 tracks on USB key or Card.
1. Insert USB key or Card. Press PROG bu on to enter
program mode.
2. Press the I
PROG bu on again followed by I
desired track followed by PROG bu on. Repeat un l all
tracks are programmed.
3. To play programed tracks, press PLAY bu on.
(NOTE: to return to normal play mode from program
mode, press STOP bu on followed by PLAY bu on. To
return back to program mode press STOP bu on fol-
lowed by PROG bu on followed by PLAY bu on)
4. To clear programmed tracks, press PROG bu on fol-
lowed by STOP bu on.
(NOTE: Programed tracks will be erased upon power off
of the BlueTooth player)
A-B Mode
(use to select a por on of a track to playback repeatedly)
While track is playing, press the A-B bu on once at the beginning of the por on you
want to select (B will begin fl ashing in the display). Press the A-B bu on again to
select the end of the sec on you wish to playback. The selected sec on will then
play repeatedly. To return to normal play, press the A-B bu on again.
ID3 bu on
Press ID3 bu on to display the tle, ar st, or album on upper display line. Tracks
without this program informa on may display nothing.
INTRO bu on
Press INTRO bu on to play fi rst 10 seconds of track, then automa cally skip to next
track. Press I Play bu on to turn off INTRO
4
Volume Control
SKIP I bu ons to select folder. Press
SKIP I bu ons for
560-0037 Rev 5 OPT-500 06/19
www.soundprojec ons.com
User Guide
For OPT-500 BT/MP3 Player
1