Table of Contents
Advertisement
4.2.
sHAde guide tAble
4.3.
self-cHeck
4.3.1.
Press the TEST Button at any time to see if it automatically switches to dark state and release it to check that the filter returns to
the light state. Shade Control; Select the shade dIn 9 to 13 based upon the welding process you will use by consulting the
"Shade Guide Table". The variable shade control knob is for internal adjustment. The welding helmet can also be used to
protect the face when cutting, from shade DIN 5 to 8. Grind mode DIN 4 prevents filter lens from auto-darkening for grinding use.
4.4.
sensitivity control
4.4.1.
The sensitivity can be set from loW to HIGH by using
the sensitivity dial. The loW setting suits excess
ambient light or with another welding machine close by.
The HIGH setting suits low amperage welding and welding
in areas with low light conditions, especially low amperage
argon arc welding. Selections between loW and HIGH
are suitable for most of indoor and outdoor welding
operations.
4.5.
delAy control
4.5.1.
When welding ceases, the viewing window automatically
changes from dark back to light but with a pre-set
delay to compensate. The delay time can be set from MIn
(0.1 sec) to MAX (1.0 sec), by Shade delay Control
The minimum delay suits spot or short welds. The
maximum delay suits heavy current welding and reduces
eye fatigue from the arc. Selections between MIn and
MAX are suitable for most of indoor and outdoor welding
operations.
4.6.
cleAning And storing
4.6.1.
Keep the sensors, solar cell and filter lens clean. Clean filter
cartridge and helmet shell by using a soapy water solution and soft cloth.
do not use solvents or abrasive cleaning detergent. Switch the product to Grind Mode and put it in a clean, dry location for storage.
8
4.7.
instAlling tHe bAttery
do not allow battery to get wet.
8
do not attempt to open the battery case.
8
Keep battery away from fire or heat.
9
Charge battery before first use.
9
4.7.1.
Push the battery into blower body until battery snaps into
position. Press the button on the end to assist with this.
4.7.2.
To release, push the button on the end in and pull out.
© Jack Sealey limited
Battery CR2032
fig.2
fig.3
Original Language Version
Sensitivity Control
Fine Shade Control
Grind/Weld Switch
Shade Range Selection Switch
PWH615 Issue 1 15/08/19
Shade Delay Control
Battery CR2032
Test Button
Advertisement
Table of Contents
