Contents Important safety instructions Before first use What water to use? Setting up the press pad Filling the Water Tank Setting up the steamer How to use your garment steamer Using the Steamer – TO STEAM Using the Steamer – TO VERTICAL IRON Using the Accessories FAQ’s...
Important safety instructions When using your appliance, basic precautions should always be followed, including the following; • Read all instructions before using this product . • This product has been designed for indoor, domestic use only. Any commercial use, inappropriate use or failure to comply with the instructions, the manufacturer accepts no responsibility and the guarantee will not apply.
Page 5
• Care should be taken when using the appliance due to the emission of steam. • DO NOT operate appliance with a damaged cord or if appliance has been dropped or damaged. To avoid the risk of electric shock, do not disassemble or attempt to repair the appliance.
Before first use • When you first use the appliance, some smoke or a harmless odour may be produced or there may be a small discharge of particles. This will not affect the use of the appliance and will disappear quickly. What water to use? •...
Setting up the press pad • Simply fix the two insert poles together and slide them into the top of your Press Pad. • Slip the two loops over the top of a door in your home near a plug socket. Top Tip! •...
Filling the Water Tank • Fill the water tank BEFORE plugging in. • The water tank is the whole purple section at the base of the unit. • Depress the white button (1) on the lower part of the front of the unit – and while depressed, pull the purple water tank away from the unit in direction shown (2).
Setting up the steamer • Once the water tank is full – plug the unit in. • Press and release the white ‘on/off’ button (on the top back of the unit) in – until the light begins to flash. • The light will flash whilst the unit is getting up to temperature. •...
• For best results, relax, take it easy and let the Verti Steam Pro do all the work for you. Applying some tension to the fabric during steaming will also improve results and reduce time taken.
Page 11
• For garments with buttons such as shirts, jackets and pants, close the first button to help straighten the fabric. To steam sleeves, start from the shoulder area and move the steamer head downwards. Steam while you pull the sleeve diagonally down with the other hand.
Using the Steamer – TO STEAM • Pull the steam trigger on the front of the unit for steam delivery. • Steam will be released through the holes in the press plate (the polished stainless steel oval section at the top front of the unit).
Using the Steamer – TO VERTICAL IRON • For a pressed finish with pin sharp creases - vertical iron. • For thicker fabrics, or garments with tough, tumble dried-in creases, it may be necessary to vertical iron to achieve best results. •...
Using the Accessories • These are designed to fit over the press plate during use, to provide additional assistance. • The small handle is at the bottom of the attachment. • Unplug the appliance first. • Attach at the top first, by fitting the cut out at the top of the attachment, over the raised lug in the front of the top of the unit (1).
FAQ’s QUESTION POSSIBLE CAUSES SOLUTIONS Why is there is no The appliance is not plugged Check that your appliance is correctly steam? in, or not switched on plugged in and switched on The water level is too low Unplug your appliance and refill it You are using the appliance for Press the steam trigger continuously for the first time...
Page 16
Extended Warranty Purchasing the Verti Steam Pro is not only an investment for your home but in monetary terms too. We appreciate this and know from Question? experience that many customers use their Verti Steam Pro daily for many years. Unfortunately, from time to time even though you follow all of the instructions and guidelines things do breakdown.
Need help?
Do you have a question about the VERTI STEAM PRO and is the answer not in the manual?
Questions and answers