Table of Contents
Advertisement
Quick Links
Smart Photoelectric Smoke Sensor
CT-SMZW2007-HM
Introduction
This product is a Smart Photoelectric Smoke Sensor, with ultra-low-power ZigBee wireless
network technology design. It is an warning device, cannot sense gas, heat, or flame, cannot
prevent or put out fire. It is capable of real-time detecting the presence of smoke, detection of
visible particles (smoldering fire) faster than ionization smoke alarms. Red LED flashes rapidly
and detectors sound alarm once detecting smoke fire danger, can alert you and your family timely.
Smoke alarms should be installed in all rooms, living room, storage areas, basements and attics
unit that fire may happen.
Technical Information
Compatible with any
network controller
ZigBee
cost savings
Battery powered and
Sensitivity and small size
www.HiotH.com
Advertisement
Table of Contents
Summary of Contents for HIOTH TECHNOLOGY CT-SMZW2007-HM
- Page 1 Smart Photoelectric Smoke Sensor CT-SMZW2007-HM Introduction This product is a Smart Photoelectric Smoke Sensor, with ultra-low-power ZigBee wireless network technology design. It is an warning device, cannot sense gas, heat, or flame, cannot prevent or put out fire. It is capable of real-time detecting the presence of smoke, detection of visible particles (smoldering fire) faster than ionization smoke alarms.
- Page 2 Specifications Radio protocol：Z-Wave Operating voltage：DC 3V (CR123A Lithium Battery) Static current：≤10μA Alarm current：≤60mA Networking way：Z-Wave Ad-Hoc Network Sound level：85dB/3m RF range：≤70m (open area) Working Temperature：-10℃~+50℃ Working humidity：≤95%RH 10. Dimension：606049.2mm Operation As shown in figure 1, there is a Reset button (which is used to carry out inclusion, exclusion or reset), a Test/Mute button and a network status indicator LED on the surface of the Smart Photoelectric Smoke Sensor, and the functions are introduced as follows: ...
- Page 3 network status indicator LED will go out. (2) If the Smart Photoelectric Smoke Sensor has been included into the network, and want to include into the new network, you must reset the device. Please long press the Reset button for 10 seconds, LED will flash slowly for 2 seconds. Reset button Network indicator Fig.1...
- Page 4 Press and hold the test panel Test/Mute button for 3 seconds, as above picture shows, until alarm status (see status table). Testing is recommended to be done at least once a week. Do not use flame for testing. Once the alarm is sure, please pay attention to it. ZIGBEE NETWORK INCLUSION Connect the power supply Press the Reset button 3 times in 1.5 seconds.
- Page 5 smoke detector is very easy, no additional wiring. Installation Renderings Ceiling mounting Fig.4 Recommended and Avoided Installation Position The preferred location to install smoke alarm is in the centre of the ceiling because Smoke, heat and combustion products rise to the ceiling and will lateral spread. Keep at least 30 cm distance from lights or decorations, and at least 15 cm away from walls and corner.
- Page 6 Smart Photoelectric Smoke Sensor Installation Anticlockwise rotating the bracket out from the installation base, then remove the battery insulating strip to make detector on power. Factory default built in a CR123A 3V lithium battery inside the detector and used a Mylar film to isolate batteries from electric circuit of the detector.
- Page 7 Safety Notice This device is a wireless communication product; please do not place the device to work in the metal container, in case the signal is blocked. The working temperature is -10°C to +50°C. This detector is designed specifically for home use, may not able to provide sufficient fire alert for public areas.
Need help?
Do you have a question about the CT-SMZW2007-HM and is the answer not in the manual?
Questions and answers