Advertisement
•
BEFORE INITIAL USE
If you are using the kettle for the rst time, it is recommended that you clean
your kettle before use by boiling a full kettle of water twice and then
discarding the water.
•
Operation
1. To ll water into the kettle, remove it from the power base (5) and open
the lid by lifting it, ll with the desired amount of water to the kettle.
Always ll the kettle between the minimum (0.5L) and maximum (1.7L)
marks. Too little water will result in the kettle switching o before the
water has boiled.
NOTE:
Do not ll the water over the maximum level, as water may spill out of the
spout when boiling. Ensure that the lid is rmly in place before connecting
the power cord to the outlet.
2. Position the kettle on the power base.
3. Connect the plug into a power outlet. The display turns ON for a moment,
all buttons and indicator lights are lit and the appliance beeps once which
means that the base is connected to the power source and the kettle is
placed on the base.
4. Close the lid and place the kettle on the power base (5), the appliance
beeps once, the display turns on and the ON/OFF (10)
blue. Below the horizontal line on the display you will see the current
water temperature which will be visible for about 5 seconds. If you do not
perform any actions, the kettle turns o automatically, at the moment, the
ON/OFF button stays blue.
5. Press the ON/OFF button (10)
The kettle turns ON and beeps, the ON/OFF button will be lit red. The
kettle boils water up to 212°F, then switches o automatically and with a
long beep.
6. If you just want to heat up the water, use the boiling temperature buttons
or
. Press once to change the temperature. The temperature setting
will be shown on the display.
without setting other functions.
5
starts to ash
www.PyleUSA.com
Advertisement
