Advertisement
4. OPERATION
4.1. Charging the battery pack
Battery pack
HBA20V2A
HBA20V4A
Warning ! Only charge in compatible 20V chargers. Use of other chargers may result in fire, damage or serious personal
injury.
The battery pack for this tool has been shipped in a low
charge condition to prevent possible problems. Therefore,
you should charge it until the green LED on the front right
hand side of the charger comes on.
Note: Batteries will not reach full charge the first time they
are charged. Allow several cycles (operation followed by
recharging) for them to become fully charged.
First read the safety instructions then follow the charging
instructions.
Plug the charger into a standard 230 V, 50 Hz mains socket
outlet, the green LED on the front left hand side of the
charger will illuminate to indicate.
Charger (Not included)
HCH20V
Do not allow the cable to become knotted or kinked.
Place the battery pack into the charger base.
(Note the battery has raised ribs which allows it to fit into
the charger only one way). Time the charge for 60/130
minutes only.
2.0 Ah-battery, charge for 60 minutes.
4.0 Ah-battery, charge for 130 minutes.
The red LED on the front right hand side of the charger will
illuminate to indicate charging is in progress. A green LED
will illuminate when the battery is fully charged.
Unplug the charger when not in use and store it in a
suitable storage cabinet.
Avoid charging your battery in freezing conditions as
charging power will not be sufficient.
When charging more than one battery pack in succession
allow at least 30 minutes for the charger to cool down
before charging an additional battery.
Always remove the battery pack and store it safely when
the tool is not in use.
Caution: If at any point during the charging process none of
the LEDs are lit, remove the battery pack from the charger
to avoid damaging the product. DO NOT insert another
battery.
5
EN
Advertisement
