Advertisement
Installation Guide: Park-It Parking Curb
Components:
Park-It parking curbs
½" rebar spikes or lag bolts with metal shields
What You Need:
Gloves, safety glasses
Traffic cones, drums or barricades for securing the site
Mallet
Heavy duty electric drill
½" masonry bit and, if installed with the lag bolts: a masonry bit required for the
metal shields
A drive socket and a power tool for installation of the lag bolts
The flexible design of the Park-It parking curb allows the product to conform to the
contour of uneven road surfaces and can be installed on both asphalt and concrete.
Installation Instructions with Rebar Spikes:
Installation of Park-It car stops with Spikes (Recommended for asphalt surfaces):
Drill ½" diameter holes (3-4" in depth) in the asphalt through the product's
STEP 1:
holes.
Drive ½" rebar spike (14" long)
STEP 2:
through the holes in the product.
Installation Instructions with Lag Bolts and Shields:
Installation of Park-It car stops with lag bolts and metal shields (Recommended for
concrete surfaces):
Use ½" or 5/8 lag bolts (6" long).
STEP 1:
GNR Technologies, 2011
Advertisement
Table of Contents
Summary of Contents for Gnr Park-It
- Page 1 A drive socket and a power tool for installation of the lag bolts The flexible design of the Park-It parking curb allows the product to conform to the contour of uneven road surfaces and can be installed on both asphalt and concrete.
- Page 2 Remove the product; re-drill the holes for the diameter and depth required by the metal shields. STEP 4: Install the metal shields, re-position the product and bolt with lag bolts. Maintenance: Requires minimal maintenance. Periodically inspect the spikes / bolts and tighten if necessary. GNR Technologies, 2011...
Need help?
Do you have a question about the Park-It and is the answer not in the manual?
Questions and answers