Setting Up Your Physiocarrier - JPMBB PhysioCarrier User Manual

setting up your Physiocarrier baby carrier
1. Hold the baby carrier upside down,
with the outside against you.
5. Push the slider of the horizontal
strap along the suspender towards
the press stud.
opening the ventilation flap
a. To open the flap, undo the central
section's straps, to eliminate creases.
2. Turn the belt so that the foam side
is against you. Rotate the belt around
your waist so that the baby carrier is
behind you.
6. Attach the male clip to the female
clip on the same side, so that the
suspender is closed.
b. Pull up the slider of the zipper.
3. Put the male clip of the lumbar belt
into the safety elastic. Attach the clip
and check that it is secure. You should
hear a click.
7. Loosen the straps of the suspen-
ders attached to the side of the
central compartment.
c. Roll up the flap. Attach it with the
elastic bands under it.
4. Adjust the strap, then bring the baby
carrier around to the front again.
8. You should first try on and adjust
the baby carrier when it is empty,
before putting Baby into it.
d. To close it, loosen the side straps,
unroll the flap and while holding the
zipper at the top, pull the slider down.
5 5