Fuego SANTANA Quick Start Manual

FUEGO
ACTIVE NOISE CANCELLING
WIRELESS EARBUDS

OVERVIEW

Thank you for purchasing the Fuego Active Noise Cancelling Wireless
Earbuds. Please read these instructions carefully for proper operation
and save for future reference.
Aircraft Aluminum Earbud
Casings
• Volume +
• Skip Track
ANC Button
Active Noise Cancellation
On/O
(opposite side)
Charging Port
• Volume –
• Repeat Track
Voice Isolating
Microphone
(opposite side)
MF Button
• Power On/O
• Play
• Pause
• Answer/End Calls

Turning ON/OFF

Power on: Hold the MULTIFUNCTION (MF) button for
3 seconds until the LED flashes blue.
Power off: Hold the MF button for 4 seconds until the
LED turns red then turns off.
Stabilizing Wing Tips
MULTIFUNCTION (MF) Button
Magnetic Ends

Connecting with Bluetooth

To play audio from a Bluetooth device,
you need to pair the device with your earbuds.
1. With the earbuds turned off, hold the MF button for
6-8 seconds to enter pairing mode, indicated by
the voice prompt "Pairing". The LED flashes blue
and red, indicating the earbuds are ready to
connect with your Bluetooth device.
2. Turn on Bluetooth mode on your device.
3. Select "Santana Fuego" to initiate pairing, and the
earbuds will automatically connect with your
Bluetooth device, indicated by a blue light and
voice prompt "Connected". Some devices ask you
to input the PIN "0000" as the password.
Note: Generally, there is a 5 minute maximum to pair
the earbuds with your Bluetooth device, otherwise
retry steps 1 to 3 to pair again.

OPERATION

VOL(+) Button
VOL(–) Button