KingShield DH020A-C Instructions

Instructions for Wired
Doorchimes & Pushes
MODEL NUMBERS -
Doorchimes -
DH020A-C Galaxy Chime
DH021A-C Tubular Chime
DH050A-C Galaxy Chime Kit
These products should be installed by a
competent person and in accordance with
the current IEE Wiring Regulations.
If in doubt, consult a qualified electrician.
Bell Pushes -
If you have bought a bell push only please
go straight to STEP 3a. in these
instructions.
DP010A-C Black Bell Push
DP020A-C White Bell Push
DP050A-C Brass Plate Bell Push
DP050AC-C Chrome Plate Bell Push
DP080A-C Brass Bell Push
DP220A-C White Bell Push
DPL12A-C 'Push A Lite' Brass Push
DPL13A-C 'Push A Lite' Silver Button
(for DPL12A-C & DPL13A-C please also
note step 3b)
DPL03A-C Lit (illuminated) Black Bell
DPL04A-C Lit (illuminated) White Bell
(DPL03A-C & DPL04A-C must be used with a
bell transformer)
This doorchime has a traditional
ding-dong sound and is easily fitted
for use with any door push.
• Bell wire required (included in
DH050A-C Galaxy Chime Kit)
• Bell push required (included in
DH050A-C Galaxy Chime Kit).
An ornate door push can be used if
preferred. (For lit bell pushes a
transformer must also be used -
KingShield Model Number
'DAT01A')
• Fixing screws included
Requires 3 x C cell R14 batteries
•
(not included)
PLEASE READ THE FOLLOWING
INSTRUCTIONS FULLY BEFORE
ATTEMPTING INSTALLATION.

1. PREPARING BELL WIRE

1. Using a knife, carefully split the bell
wire down the middle to form two
separate wires, each 30mm long.
2. Strip each wire back to expose
5mm of copper wire.
3. The process will
need to be repeated
at the other end of the
bell wire once it has
been cut to the
required length.
4. The bell wire is now
ready to wire up the doorchime to
the bell push.
2. WIRING
YOUR DOORCHIME
1. Unclip top cover.
2. Thread bell wire from the back of
the base and through the large
opening to the left of the keyhole
slot.
3. Insert either one of the stripped
ends to terminal A and the other to
terminal C, ensuring the terminal
screws are tightened securely
afterwards. Do not use terminals
marked B and D.
4. Position the base on the wall
vertically, away from opening
doors, with the battery
compartment at the bottom.
Ensure that it is less than 5 metres
away from the bell push.
5. Use one of the screws and wall
fixings to hang the base on the wall
via the top keyhole slot. Adjust the
screw for a flush fit if required.
6. Insert 3 x C cell batteries as per
markings on the inside of the case.
3a. WIRING
YOUR BELL PUSH
1. If necessary, remove the base
cover of the bell push to reveal the
terminal screws.
2. Loosen one of the terminal screws
and wrap one of the stripped ends
of bell wire around the exposed
screw thread,
ensuring the screw
is tightened securely
afterwards. Repeat
this process for the
other screw terminal
and wire.