Everite Transworld Rocket Wheels Racer V2.0 User Manual

Remote Controller V2.0
遙控器 V2.0
(Sold Separately)
(另行購買)

Installing Batteries to Remote Controller

1. Open the battery door by screw driver (not included)
2. Insert 2 x 1.5V AA (LR6) Batteries (not included)
3. Close the battery door by screw driver (not included)
If using rechargeable batteries,
●Remove rechargeable batteries from the product before charging.
●If removable and rechargeable batteries are used, they are only to be
charged under adult supervision.
遙控器電池安裝
1. 利用螺絲刀(不包含)打開電池門
2. 放入2顆1.5V AA (LR6)電池(不包含)
3. 利用螺絲刀(不包含)關閉電池門。
如果使用可充電電池
1. 請於充電前取出充電電池
2. 如果使用可拆卸和可充電電池，則只能在成人
監控下充電。

FCC Regulatory Compliance

Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment o and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit di erent from that to which the receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help.
Warning: changes or modi cations not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.

RF Exposure Compliance

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
2.4
GHz
Rocket Wheels Racer V2.0
TM
Rocket Wheels 賽車 V2.0
TM

Vehicle charging

Plug both ends of the USB charging cable into the vehicle and any USB
power device. The end of the USB cable will has red light during charging.
While it turns to green light, charging has been completed. Charging
time is about 30 - 50 minutes.
Chargers used with the toy are to be regularly examined for damage to
the cord, plug, enclosure and other parts, and that, in the event of such
damage, the toy must not be used with this transformer until the damage
has been repaired.
The rocket wheels racer is only to be connected to Class II equipment
bearing the symbol
車輛充電
將USB充電線的兩端分別插入車輛和任何USB電源
設備，USB線的末端會亮起紅燈，表示正在充電。
當USB線的末端亮起綠燈時即表示已完成充電。充
電時間約30 - 50分鐘。
玩具使用的充電器應定期檢查其USB線，插頭和其
他部件是否損壞，發現損壞時應停止使用，直至修
復完好。
車輛只能連接到帶有
RW-
Rocket Racer V2.0
USB Charging Cable Decoration Sticker
USB 充電線
裝飾貼紙
符號的II級設備
A2284RW-HK-V02
User Manual
使用説明書

Battery Safety Information

In exceptional circumstances, batteries may leak uids that can
cause a chemical burn injury or ruin your product. To avoid battery
leakage: Do not mix old and new batteries or batteries of di erent
types. alkaline, standard (carbon-zinc) or rechargeable
(nickel-cadmium). Insert batteries as indicated inside the battery
compartment. Remove batteries during long periods of non-use.
Always remove exhausted batteries from the product. Dispose of
batteries safely. Do not dispose of this product in a re. The batteries
inside may explode or leak. Never short-circuit the battery
terminals. Use only batteries of the same or equivalent type, as
recommended. Do not charge non-rechargeable batteries.
電池安全信息
在特殊情況下，電池可能會漏出液體造成化學
性的灼傷或損壞您的產品。為了避免電池漏液
：不要混合使用新舊電池或不同類型的電池，
如鹼性，標準（碳鋅）或可充電（鎳鎘）。以
電池倉內表示正確的極性插入電池。在不使用
長時間不使用時應取出電池。請從產品中取出
耗盡的電池。安全地處理電池。不要用火處理
本產品，電池可能會爆炸或洩漏。千萬不要短
路電池端子。只能使用相同或同等類型的電池
。非充電電池不可充電。