Air Relax AIRRELAX-1 Quick Manual

Please Read This Quick Guide. Thank You.

Main Parts:

Air
Socket
1. The T Terminal has already been connected to the
2. Attach gently the
Hose Plug
(No need to disconnect it after every use.)
Cuffs, zip cuffs fully, and secure velcro straps, otherwise it will pop. Do not
3. Put on the Leg
panic if it happens just turn off your device and zip it again, properly.
4. Plug in the device to US electrical outlet ONLY. Press
5. How to operate Modes: Default mode begins. You can choose any mode (please see the
manual, Page 11), start from the lowest pressure. You can adjust to a higher level of pressure
if desired. Press the "MODE" button once to change the mode.
"A" Each individual chamber will inflate and deflate one at a time starting at the ankles.
"B" Each individual camber will inflate and stay inflated until all four chambers are filled.
"C" All four chambers will inflate together and deflate at the same time.
"Point" Mode. Use this Mode to target a specific section to inflate and deflate repeatedly.
See manual, Page 10.
6. Device will turn off automatically after 15 minutes.

Tips:

1. Sometimes you can put the Leg Cuffs on without unzipping them (like boots or pants).
2. Put fresh socks on before every use.
3. Once device is off, the air starts to slowly deflate from the cuffs.
It takes some time, please be patient.
4. Be gentle with rubber hoses and plastic T-connectors.
5. Please do not hesitate to contact us if you have questions about the device.
air relax
AIRRELAX-1
T Terminal
Hose
Device
Plug
connector to the
air relax
Air
Hose
Leg Cuffs for you.
Air Socket located on the front of the
Power button.
air relax
Leg Cu s
Device.
air relax