Advertisement
Familiarize yourself with the
3
product.
Rear View:
x
Access screw
PCIe or Thunderbolt
cable connector
One add-in card slot
Power Supply Connector
Inner Components:
Cable Adapter Board
ATX Auxiliary
Power (for GPUs)
Sled
PCIe x16 Slot
Backplane
Configuring the µCUBE Window:
4
Opening the µCUBE Window
1. Remove all items from their packaging including:
a. µCUBE Window enclosure (includes
chassis, sled with backplane and target
cable adapter)
b. (1) Host cable adapter card
c. (1) Cable
d. (1) External power supply
Add-in Card Installation
2.
2. Remove the sled from the µCUBE Window
a.
a. Unscrew the access screw located at
2. Remove the top panel.
the top of the sled.
a. Unscrew the thumb screw on the rear of
b. Remove the sled from the chassis.
the unit, then slide the top cover towards
the rear of the chassis and remove.
3. Remove the Riser Stabilizer.
3. Install your add-in card
a. Simply lift the front edge and slide
Screwdriver
towards the back of chassis then lift.
a. Carefully align the add-in board connector
with the PCIe connector on the backplane
and press firmly into place.
b. Replace the screw on top of the card
Screw
bracket, securing the newly-installed
board into place in the tray.
c. Always use a slot cover for any unused
slots on the rear panel.
4. Replace the sled
60 x 60 x
25mm fan
a. Slide the sled back into the chassis.
b. Replace the access screw at the top of the
sled.
Cabling the µCUBE Window to your computer
5. For PCIe connection to your PC or workstation
a. To insert the PCIe cable, line up the
keyed side of the cable connector with
the keyed side of the connector on the
board and insert.
i. Pull back the green tab on the
retractor to allow the cable to lock
into place.
ii. The teeth of the cable connector
must be completely seated.
b. Install the cable adapter in a PCIe slot in
your PC or workstation.
i. Place the cable adapter card in an
open slot in your computer (the
cable adapter will only operate at
the base speed of the slot. Ex: a x8
card in a x16 slot operates at x8
speeds.)
ii. Fasten the adapter card in the slot
by tightening the screw on the slot
cover.
6. For Thunderbolt Connection
a. Connect the Thunderbolt cable to the
Thunderbolt connector in your workstation
or laptop.
i.
The cable can be connected to
either of the Thunderbolt
connectors on the µCUBE
Window.
7. Insert the power cable and turn on your computer
to power up the µCUBE Window.
8. Install any driver required for the add-in card(s) on
your computer.
Advertisement
