Advertisement
casa
workstation
#8160
CASA SALON WORKSTATION/MIRROR
comfortel.com.au
ASSEMBLY
STANDARD : SINGLE BENCH
1
Veneer Frame with Mirror
2
Melamine Bench Top - Single
3
Screws x 6
ASSEMBLY
1. Position Bench top into frame so screw holes meet.
2. Tighten each screw into each hole on both left and right side,
ready for mounting.
owners manual
1
3
2
Advertisement
Table of Contents
Related Manuals for comfortel Casa
Summary of Contents for comfortel Casa
- Page 1 #8160 CASA SALON WORKSTATION/MIRROR ASSEMBLY STANDARD : SINGLE BENCH Veneer Frame with Mirror Melamine Bench Top - Single Screws x 6 ASSEMBLY 1. Position Bench top into frame so screw holes meet. 2. Tighten each screw into each hole on both left and right side, ready for mounting.
- Page 2 IMPORTANT PLEASE READ THESE SAFETY INSTRUCTIONS GENERAL SAFETY 1. Read carefully and keep these instructions in a safe place. WEIGHT: 36kg 2. Use this product only for its intended function and do not use attachments not recommended by the manufacturer. 3.
- Page 3 INSTALLATION: WALL MOUNTING All measurements are in MM. BEFORE INSTALLING YOU SHOULD CONSIDER THE FOLLOWING: IMPORTANT Allow for the necessary room around the unit for free movement. When installing,position bench so it is 800 - 860mm from the floor. WALL FIXINGS NOT SUPPLIED. This is the recommended bench height.
- Page 4 #8160 CASA WORKSTATION Comfortel Furniture Pty Ltd. assumes no responsibility for any errors that may appear in this document nor does it make expressed or implied warranty of any kind with regard to this material, including, but not limited to, the implied warranties of merchantability and fitness for a particular purpose.
Need help?
Do you have a question about the Casa and is the answer not in the manual?
Questions and answers