Download Print this page

Using Your Radio - Jeremy’s Radio Emporium Standard Series Owner's Manual

Enhanced radio jeep am-fm (with clock) 56009001, 56007519 or equiv

Advertisement

Using Your Radio

Powering On and Off: Rotate the volume knob clockwise to
power the unit on. Rotating the volume knob fully
counterclockwise will turn it off again. When powered off, the
display will still illuminate and the clock will be shown.
Clock Adjustment: To set the clock, hold the "CLK" button until
the clock display begins to flash. To adjust the hour, press either
the SEEK or TUNE buttons in either direction. To adjust minutes,
press the CLK button again. Once finished, press the CLK button
again to set the time. The time will also be set if no buttons are
pressed for several seconds.
Balance and Fade Controls: Your radio is equipped to drive four
audio channels. To adjust left-to-right balance, pull the volume
knob out towards you until you hear a click. When pulled out,
turning the volume knob will adjust balance. When finished, push
the volume knob in again. To adjust front-to-rear fade, turn the
pointed knob behind the volume knob. Moving the pointer
upward will turn off the rear speakers, and vice versa.
Treble and Bass Controls: To adjust treble and bass, move the
sliders above the screen to the left or right. The neutral position
for each control is marked by a "0" on the radio's face. Caution:
when playing at high volumes, increasing the bass level can cause
audio distortion.
Radio Band Controls: To switch between AM and FM modes,
press the AM or FM buttons. To seek for a powerful station, press
the SEEK button in either direction. To tune for stations in
individual steps, press the TUNE button in either direction.
NOTE: On Mark II Enhanced Radios, AM functionality is
disabled by default to improve the sound quality of the
auxiliary input. Contact Jeremy's Radio Emporium for
instructions for re-enabling AM reception.
2017 Jeremy's Radio Emporium
2

Advertisement

loading