Universal Furniture 356829 Instruction Sheet

Thank you for purchasing this quality product. Be sure to check all packing material carefully for small
parts that may have come loose inside the carton during shipment.
Caution: (1) These parts are cumbersome and heavy. This product can best be assembled with the
assistance of one or more persons in order to prevent personal injury and to insure parts are not damaged
during the assembly process. If dirty, clean finished parts with mild dishwashing liquid and water solution
applied on damp cloth. Cloth should not be excessively wet. Polish finish with soft cloth and an industry
recognized furniture polish.
(2) To prevent damage to your floor or carpet, please check the bottom of each piece of furniture for
stain residue and rough surfaces and also check for staples or nails left after removing the packaging material.
The manufacturer will not be held responsible if preventative steps are not taken prior to installation.
(3) Unpack and dispose of all packing material but be careful not to throw away any assembly parts or
hardware. Read the instruction sheet and parts list carefully. Remove all staples and screws used for
packaging carefully using pliers and or screwdrivers to prevent injury and scratching or damaging flooring.
(4) During normal use everyday, screws, bolts, nuts and wooden plugs may loosen up. They should be
periodically inspected and re-tightened to prevent damage to the furniture and (or) personal property or cause
injury. Always check to be sure all hardware on this list and the above mentioned components is attached to
the furniture properly and kept tightened at all times.
PARTS LIST:
# Description
A Leg
B Table Frame
C Bottom stretcher
Metal Plug
D
Assembly Procedure
Step 1: Unpack, inspect, and read assembly instruction carefully. Lay out the parts and hardware.
Make sure the quantity of each is correct.
Step 2: Attach the threaded rod ( 1 ) to the leg ( A ).
Step 3: Place the Table Frame (B) upside down in a smooth, clean, and soft surface, and then fix the
leg ( A ) to the table frame ( B ) shown as the sketch. Please tighten the bolts for this step.
Step 4: Insert the bottom stretcher ( C ) into the leg ( A ), attach the metal plug ( D ) to the threaded
rod of the foot ( E ) and then fix the foot ( E ) into the leg ( A ), please tighten the foot ( E )
for this step.
Step 5:.Please tighten all the bolts and turn the table upright, place the Glass Top ( F ) to the Table
Frame ( A ).
Assembly is now complete.
INSTRUCTION SHEET
356829
Qty.
6 pcs
1 pc
1pc
6 pcs
: (Please follow the sketches below.)
GOOD, AFFORDABLE, SMART DESIGN.
PROXIMITY COCKTAIL TABLE
# Description
E Foot
F Glass Top
G Hardware Pack
Qty.
6 pcs
1 pc
1 bag