Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Summary of Contents for CAB Battery Pack 2 EOS1
- Page 1 Operator's Manual Battery Pack Made in Germany...
-
Page 2: Table Of Contents
Operator's Manual for the following products Table of Contents Type Battery Pack 2 EOS1 Battery Pack 4 EOS1 Introduction ..........3 Battery Pack 2 EOS4 Battery Pack 4 EOS4 1.1 Product Description .........3 1.2 Instructions ..........3 1.3 Intended Use ...........4 Edition: 03/2015 - Part No. 9009624 1.4 Safety Instructions ........4... -
Page 3: Introduction
Introduction 1.1 Product Description The Battery Packs are designed as power supplies for the cab printers EOS1 mobile and EOS4 mobile. 1.2 Instructions Important information and instructions in this documentation are designated as follows: Danger! Draws your attention to an exceptionally grave, impending danger to your health or life. -
Page 4: Intended Use
• The Battery Packs are exclusively designed as power supplies for the cab printers EOS1 mobile and EOS4 mobile. Any other use or use going beyond this shall be regarded as improper use. The manufacturer/supplier shall not be liable for damage resulting from unauthorized use; the user shall bear the risk alone. -
Page 5: Environment
Introduction Danger! Danger to life and limb from power supply. Do not open the device casing. Warning! This is a class A product. In a domestic environment this product may cause radio interference in which case the user may be required to take adequate measures. -
Page 6: Installation
Installation 2.1 Contents of Delivery • Battery Pack • Power Cable • Operator's Manual Notice! Please keep the original packaging in case the battery pack must be returned. 2.2 Mounting Fig. 1 Mounting Set up the battery pack on a level surface. ... -
Page 7: Connecting
Installation 2.3 Connecting Fig. 2 Connecting Notice! Charge the battery pack completely prior to the first use ! 4. Charging Ensure that battery pack and printer are switched off. Connect cable (7) to the printer. -
Page 8: Operation
Operation 3.1 Switching on Switch on the power switches at battery pack (4, Fig. 1) and printer (5, Fig. 2). • The printer can be operated in the same way as a printer with mains supply. • In battery operation mode the charge control LED L1 - L3 are switched off. •... -
Page 9: Charging
Charging Attention! Risk of premature loss of performance! Charge the battery pack at least every six months also if it is not used. Notice! During the battery charging the printer can be used. Plug the power cable into the power connection socket (7, Fig. 2). ... -
Page 10: Licences
• Directive 2011/65/EU on the restriction of the use of certain hazardous substances in electrical and electronic equipment EU Declaration of Conformity https://www.cab.de/media/pushfile.cfm?file=2702 5.2 FCC NOTE : This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules.
Need help?
Do you have a question about the Battery Pack 2 EOS1 and is the answer not in the manual?
Questions and answers