Advertisement
Quick Links
01
Put the document holder flat
with the blank cardboard facing
upwards. Fold the two external
flaps as shown
(green dots).
04
Hold the flaps in place and lift the
lower section 90°.
07
Firmly close the edge and
move the central flap
towards you 90°.
the arches)
Optimeo folds in 4 parts for your comfort at work
ASSEMBLY
INSTRUCTIONS
for the Opti-1 ergonomic
document holder
02
Raise the flaps 90°
05
Start folding the lower section
while folding the two internal
flaps
08
Hold the central flap while
folding the two side flaps inside.
(with
.
(green dots)
(green dots).
DESIGNED IN FRANCE
REGISTERED DESIGN
03
Fold them against the back
(the side edges are raised).
06
Finish folding the lower section
by pressing on the edge you have
created.
09
Insert the tabs into the slots.
.
Advertisement
Summary of Contents for OPTIMEO Opti-1
- Page 1 DESIGNED IN FRANCE Optimeo folds in 4 parts for your comfort at work REGISTERED DESIGN ASSEMBLY INSTRUCTIONS for the Opti-1 ergonomic document holder Raise the flaps 90° Fold them against the back Put the document holder flat with the blank cardboard facing (green dots) (the side edges are raised).
- Page 2 Run any cables there may be under the document holder arches. Do not forget to fold away the feet at the back of your keyboard. We hope you enjoy working with the benefit of the Opti-1! Watch the assembly how-to video here: https://www.optimeo-prevention.com/opti-1-montage...