BulletHD OVERVIEW
②Power / Shutter
①LED
⑥MicroSD Card Slot
⑤USB
⑨1080P / 720P Mode Switch
INITIAL SET UP
1. Make sure the BulletHD is OFF before adding or removing the memory card!
2. Screw out the rear cap (open) located at the back of the BulletHD ③.
3. Install a micro SD memory card (max up to 32GB) into the rear slot. To insert
the micro SD card, slide the micro SD card into the card slot on the back of
the BulletHD with the card label facing down. The micro SD card will click into
place once it is inserted past flush with the Bullet HD. Use your fingernail to
do this. Then screw in the rear cap till is complete lock.
4. If no micro SD memory is inserted in the BulletHD, the LED on top of the
camera will blink red and blue.
5. When using a micro SD memory card in the BulletHD, there should be no
data from other devices on the card. If you are using a micro SD memory
card for the first time in the BulletHD, first you should format the card in your
computer.
③Rear Cap
⑦Battery
⑩Stabilizer / Firmware
④Mode Switch
⑧Microphone
Need help?
Do you have a question about the PRO2 and is the answer not in the manual?