AVERY
™
PULL-DOWN
KITCHEN & BAR FAUCET
Thank you for selecting American Standard...
the benchmark of fine quality for over 100 years.
To ensure that your installation proceeds smoothly-please read
these instructions carefully before you begin.
RECOMMENDED TOOLS
Flat Blade Screwdriver
1
INSTALL FAUCET WITH OR WITHOUT DECK ESCUTCHEON
(A) Installation less DECK ESCUTCHEON
• Make certain the SEAL (10) is properly seated in bottom recess of the SPOUT (2). Insert supply HOSES (3), SPRAY HOSE (4)
and SHANK (5) through mounting hole and seat SPOUT BASE onto sink or mounting surface. Do not use putty.
• Insert HOSES (3) through RUBBER WASHER (6), BRASS WASHER (7), and threaded LOCKNUT (8).
• Assemble RUBBER WASHER (6), BRASS WASHER (7), and threaded LOCKNUT (8) onto SHANK (5) from underside
of sink or mounting surface. Hand tighten LOCKNUT (8).
• Use a screwdriver to tighten SCREWS (9) on LOCKNUT (8). Work your way around LOCKNUT (8), tightening the screws
slightly each time until all are snug to ensure even pressure.
(B) Installation with DECK ESCUTCHEON (optional)
• Make certain the SEAL (10) is properly seated in top recess of DECK ESCUTCHEON (1) and SEAL (12) is properly seated
in bottom recess of DECK ESCUTCHEON (1). Do not use putty.
• Screw in two THREAD RODS (13) onto bottom of DECK ESCUTCHEON (1).
• Insert SUPPLY HOSES (3), SPRAY HOSE (4) and SHANK (5) through hole of DECK
ESCUTCHEON (1), and mounting surface.
• Follow mounting instructions above
to secure faucet to mounting surface.
Thread the MOUNTING NUTS (11) to
secure DECK ESCUTCHEON.
Product names listed herein are trademarks of AS America, Inc.
© AS America, Inc. 2018
INSTALLATION
INSTRUCTIONS
Phillips Screwdriver
A
SPOUT BASE
5
4
7
8
- 1 -
4901.300
4901.410
Adjustable Wrench
Turn off water at
CAUTION
main supply
2
10
3
SINK OR
MOUNTING
SURFACE
6
9
Certified to comply with ANSI A112.18.1M
Plumbers' Putty or Caulking
B (OPTIONAL)
10
SPOUT BASE
13
5
3
11
4
6
7
8
9
M965801 Rev.1.2 (11/18)
1
12