Advertisement
Assembly
1. Check that the On/Off Switch
set to off before assembly.
2. Place the Bowl
Unit
ensuring the Lower Cut-
Out Switch
position correctly will prevent the
Potato Peeler from operating.
3. Place the the Peeling Disk*
the axis inside the Bowl
4. Add enough potatoes to the Bowl
to cover the Peeling Disk*
(maximum of 1kg).
5. Add a little water (maximum 200ml)
to the Bowl
6. Place the Lid
with the 'T' section to the rear. The
'T' section must slot into the Upper
Cut-Out Switch
bowl.
7. Push both the front and rear Lid
Clips
upwards to lock the Lid (4)
into place.
Tips
Do not use baking potatoes, as
■
these are too large, for best results
cut your potatoes so that they
measure no more than 5cm x 5cm.
Wash potatoes in fresh water before
■
cooking.
Sprinkle with flour, before putting in
■
the oven.
onto the Base
is aligned. Failure to
onto
.
aid peeling.
onto the Bowl
at the rear of the
Peeling Potatoes
is
1. Plug
Mains socket
2. Set the On/Off Switch
3. The Potato Peeler will begin to
function. (The appliance may
vibrate during use but the rubber
feet keep the appliance from moving
significantly).
4. As a rough guide, the Potato Peeler
should take around 2 minutes
to peel a quantity medium sized
potatoes. Due to potatoes varying in
size and shape, this time may vary.
Smaller potatoes will give better
results than large.
5. Check progress regularly, never allow
the machine to operate continuously
for longer that four minutes and
allow ten minutes between each
four minute use period.
6. Once potatoes are peeled set the
On/Off Switch
7. Unplug
the Mains socket.
8. Remove the potatoes from the Bowl
.
9. The Potato Peeler can not remove
skin from recesses or irregular
shapes. Remove any remaining skin/
eyes by hand using a small knife.
Wash potatoes in fresh water before
■
cooking.
Electric Potato Peeler
the Potato Peeler into the
to
O
to
(Off).
the Potato Peeler from
—
(On).
Advertisement
